User manual ZANUSSI ZDW416

[. . . ] INSTRUCTION BOOKLET DISHWASHER ZDW 416 FS ZDW 416 BU CONTENTS Warnings . . page Positioning, levelling, adjusting the worktop . . page Installing and securing the machine under a kitchen unit, fitting a decor panel on the door . . page Fitting under acounter, securing under a counter . [. . . ] Top up with rinse aid when the indicator (B) becomes clear D B m a x 6543 - MIN = 15 ml - MAX = 30 ml A DE07 BR01 BR03 Remember to CLOSE the lid after every refill. Caution Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Adjusting the Dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 - minimum dose, position 6 - maximum dose). Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes. The amount of detergent to be used varies depending on how soiled the dishes are and the type of dishes being washed. We recommend the amounts shown in the programme chart on the next pages. After filling the dispenser with detergent, close the lid. All the programmes with prewash require a small extra amount of detergent of approximately 5g to be poured over the lid of the dispenser, as shown on the picture. DE02 C x At the end of any washing programme the lid is always open, ready for the next wash. Since not all detergents are the same, you should also consult the instructions on the packet. Remember that insufficient quantities of detergent will produce poor washing results whereas an excessive amount of detergent does not improve washing results and is also wasteful. Using no more than the correct amount of detergent also contributes to reducing pollution. m a 6543 BR02 Caution: Do not put liquid detergent into the rinse aid compartment. PBR06GB 8 M M IN AX 21 21 Loading your machine Before placing dishes in the machine, remove any scraps of food from the plates (small bones, toothpicks, fish bones, scraps of meat and vegetables, fruit skins etc. ) to avoid clogging the filters and consequently reducing performance. Open the door and slide out the baskets to load the dishes. The cutlery basket is in two parts which can be separated to give greater loading flexibility. To separate the two parts, slide them horizontally in opposite directions and pull them apart. To reassemble, reverse the procedure. Use of the lower basket The lower basket is designed to take saucepans, lids, plates (up to 27 cm in diameter), salad bowls, cutlery etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the upper spray arm can turn freely. UI07 The two rear rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. To lower the prongs: slightly pull them upward and let them drop down (see picture); to bring them back to the standing position, just pull them up again. UI22 IEC 436 / DIN 44990 UI18 UI21 Cutlery should be placed in the removable cutlery basket with the handles facing downwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upward. Mix spoons with the other cutlery to prevent them sticking together. Teaspoons may be loaded into the special slots provided in the cutlery basket handle. PCE24GB 9 Use of the upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates up to 24 cm in diameter), salad bowls, cups and glasses; these should be arranged as shown in the pictures. Glasses with long stems can be placed upside-down in the raised cupracks. Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position as follows: Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. A RC01 US13 IEC 436 / DIN 44990 When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup-racks. US12 Caution When loading the dishes, ensure that you do not cover the water inlet funnel in the middle of the upper basket. US16 US16 Before closing the door, ensure that the spray arms can rotate freely. PCE25GB 10 HELPFUL HINTS For best washing results: Before loading, remove all scraps of food and soak very heavily soiled pots and pans. [. . . ] To take it out, remove the spray arm by pressing the two tongues (E), turn the ring (F) anticlockwise (towards the left) and then slide the whole part out. Refit the filter following the above instructions in reverse order. E A F MA01 Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the water inlet tap, disconnect the water inlet pipe and empty it. [. . . ]