User manual ZANUSSI ZEL296

[. . . ] REFRIGERATOR ZEL 296 INSTRUCTION BOOKLET 2222 237-92 IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety. You MUST read it carefully before installing or using the appliance. Installation · · · This appliance is heavy. [. . . ] Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG ODOUR. External cleaning Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. 6 PR259 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. Changing the light bulb Unscrew the light cover and then pull it outward toward the middle of the cabinet. Unscrew the bulb and replace it with a new 25 watt bulb (available from your nearest Service Force Centre). Replace the light cover by sliding it into its original position and replacing the screw. Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment behind the salad crispers. Use the defrost cleaner provided which you will find already inserted into the discharge hole. Remember to wash the defrost cleaner in hot soapy water at regular intervals. Dry throughly before replacing. D037 7 SOMETHING NOT WORKING If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre Symptom No power to the appliance Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown. The light does not come on Ensure that the bulb is correctly fitted. Check the door light switch is not jammed. The temperature in the fridge Check the thermostat control knob in the fridge is turned to the correct setting relative to ambient conditions. Check the ambient temperature is within the appliance's operating limits, please refer to the installation section in this instruction book. Relocate the appliance if necessary. The compressor runs continously Adjust the thermostat control knob to give correct temperature control. See "Setting the temperature". Large quantities of food have recently been placed in the cabinet and/or door is frequently opened. Check that air ventilation is not obstructed. Noise Water under the salad crispers Refer to normal operating sounds. (see Maintenance and Cleaning). If after the above checks your appliance still does not operate correctly, contact your local Service Force Centre. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. [. . . ] For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. [. . . ]