User manual ZANUSSI ZERB 8441

[. . . ] ZANUSSI FRIDGE - FREEZER ZERB 8441 INSTRUCTION BOOK GB 200370055 A/ZE/14. (05. ) This instruction book contains safety precautions, information on use and helpful hints and tips. To ensure you use this appliance effectively and safely, please read this instruction book carefully before installing or using this appliance and retain for future reference. The symbols below help you to find things more easily: Safety precautions Warnings and Safety information Hints, useful information Environmental information The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] Open the doors of both parts of the appliance and clean the refrigerator according to 'Regular cleaning'. Maintain and clean the freezer as following: Sweep off the melting water with a cloth or sponge in direction of sides of the cooling plates. The melting water swept down gathers in the outlet channel practically formed in the bottom of the appliance and can be removed according to figure. Put an adequately high bowl or dish under the outlet. The bowl in figure is not a piece of accessories to the appliance!Wipe the surfaces after defrosting and leading the water out. Put the mains plug into the mains socket and put foods taken out back to their places. It is recommended to operate the appliance at the highest position of the thermostatic control for some hours so that it can reach the sufficient storing temperature as soon as possible. 10 Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time using lukewarm water then wipe it (it is practical to clean the inside of the freezer and defrost it at a time). Household cleaner or soap must not be used. After breaking the circuit wash the appliance with lukewarm water then wipe it. After cleaning apply voltage to the appliance. It is recommended to remove the dust and dirt collected on the back of the refrigerator and the condenser and to clean the evaporative tray on top of the compressor once or twice a year. When the refrigerator is not in use In case the appliance will not be used for a long time follow these steps: Break the circuit of the appliance. Leave the door open to avoid a build up of air inside. Trouble shooting How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. Press the rear hook (1) and at the same time slide the cover in the direction indicated by the arrow (2). (Bulb type: T 25 230-240 V, 25 W, E 14 thread) After changing the bulb replace the cover, snap it in place and apply voltage to the appliance. If something does not work During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, but means normal operation. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before breaking the circuit. 11 Problem Possible cause It is too warm in the Thermostatic control can be set wrongly. If products are not cold enough or placed wrongly. [. . . ] (fig. 2) Fit the freezer door to the lower door hinge pin (f). (fig. 3) Fit the refrigerator door to the upper door hinge pin (d) then slightly tilting both doors fit the pin of the double door hinge (m) into the left drill of the refrigerator door. Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Do not forget to replace the plastic spacer (b) under the hinge. [. . . ]