User manual ZANUSSI ZERB3120

[. . . ] REFRIGERATORFREEZER ZERB 3120 INSTRUCTION BOOKLET 2223 023-71 IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of safety. You MUST read it carefully before installing or using the appliance. Installation · · · This appliance is heavy. [. . . ] Do not push food together too much, try to allow air to circulate around each item. NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG ODOUR. D411 External cleaning Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. You MUST ensure that the appliance is switched OFF. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. Unscrew the light cover and then pull it outward toward the middle of the cabinet. Unscrew the bulb and replace it with one of the same power (the maximum power is shown on the light diffuser) available from your nearest Service Force Centre. Replace the light cover by sliding it into its original position and replacing the screw. Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. D037 PR259 Important When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment behind the salad crispers. Use the defrost cleaner provided which you will find already inserted into the discharge hole. Remember to wash the defrost cleaner in hot soapy water at regular intervals. Dry throughly before replacing. 8 Freezer When the frost has reached a thickness of up to 4mm it can be removed using the ice scraper provided with the appliance. During this operation it is not necessary to disconnect the appliance from the mains and remove the food. Never use metal tools for this operation. For complete defrosting (once or twice a year) proceed as follows: turn the thermostat dial to the «OFF» position (O) or disconnect the appliance from the mains. Remove any food from inside the freezer and fridge, wrap it in several sheets of newspaper and store in a cool, dry place. Leave the door open and insert the ice scraper under the channel in the centre of the lower part of the appliance; place a low-sided container beneath the scraper to collect the water (see fig. ). - D068 - Clean and dry thoroughly. Replace the scraper in one of the drawers . Reconnect the appliance to the mains or reset the thermostat to a functioning position. After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. Important When defrosting the freezer, the fridge is also controlled by the thermostat and will not be operational during this period. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 9 SOMETHING NOT WORKING Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: Symptom No power to the appliance Solution Check there is power at the socket. [. . . ] The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Service Force Centre. 87/308 of 2. 6. 87 relative to radio interference suppression. [. . . ]