User manual ZANUSSI ZERB8441

[. . . ] ZANUSSI FRIDGE - FREEZER ZERB 8441 INSTRUCTION BOOK GB 200370292 A/ZE/14-1. (05. ) This instruction book contains safety precautions, information on use and helpful hints and tips. To ensure you use this appliance effectively and safely, please read this instruction book carefully before installing or using this appliance and retain for future reference. The symbols below help you to find things more easily: Safety precautions Warnings and Safety information Hints, useful information Environmental information The symbol on the product or on its packaging indicates that this product may not be treated as household waste. [. . . ] Spare bulbs are available from your local Service Force Centre. 10 If something does not work If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Symptom Possible cause It is too warm in the Thermostatic control can be set refrigerator. If products are not cold enough or placed wrongly. The door does not close tightly or it is not shut properly. It is too warm in the Thermostatic control can be set freezer. The door does not close tightly or it is not shut properly. Products in big quantity to be frozen were put in. Products to be frozen are placed too closely to each other. During automatic defrosting frost melts on the back plate. The outlet of the chamber can be clogged up. Products placed in can prevent water from flowing into the collector. The melting water outlet flows not into the evaporative tray above the compressor. Doors are not shut properly or do not close tightly. Solution Set the thermostat knob to higher position. Place the products to the appropriate place. Check if the door closes well and the gasket remains clean and undamaded. Set the thermostat knob to higher position. Check if the door closes well and the gasket remains clean and undamaded. Wait some hours and then check the temperature again. Place the products in a way so that cold air could circulate among them. Water flows at the back plate of the refrigerator. Water flows into the chamber. Clean the outlet. Replace the products so that they do not touch the back plate directly. Put the melting water outlet to the evaporative tray. [. . . ] (fig. 4) Put the appliance to its place, set it level, and apply to voltage it. In case you do not want to perform the procedures above, call your local Service Force. Technicians will accomplish the refitting expertly for charge. fig. 4. 16 Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ]