User manual ZANUSSI ZF21/9S

[. . . ] The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with this symbol. Our contribution to the protection of the environment: we use recycled paper. Contents Warnings Disposal Tips for environmental protection Technical specifications Installation Unpacking Positioning and levelling Water inlet Water drainage Electrical connection 61 62 62 62 63 63 63 63 64 64 Before loading the laundry Maximum loads Laundry weights Removing stains Detergents and additives International wash code symbols Operating sequence Programme tables 68 68 68 69 69 70 71-72 73-74 Maintenance Bodywork Door seal Detergent dispenser drawer Water inlet filter Drain pump Emergency emptying out Frost precautions 75 75 75 75 75 75 76 76 Your new washing machine Detergent dispenser drawer 65 65 Use Control panel Controls Washing hints Sorting the laundry Temperatures 66 66 66-67 68 68 68 60 Something not working? 77-78 Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation · All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed. [. . . ] Rub particularly soiled areas with a special detergent or detergent paste. Remove hooks or tie them up in a bag or net. Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Then run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine. The lights corresponding to the different phases making up the selected programme light on. The light of the START/PAUSE button starts to flash. 5. Select the required options The light corresponding to the depressed button illuminates. 1. Place the laundry in the drum Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Measure out the detergent Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you have selected the prewash, pour detergent into the appropriate compartment marked . 6. Start the programme Depress START/PAUSE-button, the corresponding pilot light stops flashing. The DOOR light illuminates and only the pilot light WASHING remains lit. 3. [. . . ] · Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. · The cap on the emergency emptying hose has not been replaced after cleaning the pump. · Unsatisfactory washing results: · Too little or too much detergent has been used. · An unsuitable detergent has been used. [. . . ]