User manual ZANUSSI ZF22/10

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel provided, pour in the salt until the container is full. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. Replace the cap tightly turning it clockwise until it stops with a click. Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. The salt container will require topping up periodically. The salt cap has a refill indicator window in the centre. A green float is clearly visible when there is salt inside the container and almost disappears when the salt has finished reminding you to add salt. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). The cutlery basket is in two parts which can be separated to give greater loading flexibility. To separate the two parts, slide them horizontally in opposite directions and pull them apart. To reassemble, reverse the procedure. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the basket is in the higher position you will not be able to use the cup rack(s). After loading your machine always close the door, as an open door can be a hazard. The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. Glasses with long stems can be placed upside down in the cup racks. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. In case that plates are loaded in the upper basket: load them starting from the rear positions of the basket; tilting them slightly forwards and avoiding the front positions near the door. Before closing the door, ensure that the spray arms can rotate freely. 10 Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more than the correct amount of detergent contributes to reducing pollution. [. . . ] The programme will continue from the point at which it was interrupted. If the fault code reappears contact the Service Force Centre. For other combinations of fault codes not described in the above chart, please contact your Service Force Centre. . . . there are problems when operating the dishwasher Malfunction Possible cause The dishwasher door has not been properly closed. The programme does not start The main plug is not plugged in. [. . . ]