User manual ZANUSSI ZF50/16

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, clean and maintenance. Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. [. . . ] Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out a programme with the prewash phase, pour it into the compartment marked . If required, pour fabric softener into the compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Select the required programme by means of the programme selector dial (1) Turn the programme selector dial to the required programme. The green light of button 8 starts blinking. It can be turned either clockwise or anticlockwise. On position «O» the programme is reset and the machine is switched OFF. At the end of the programme the selector dial must be turned to position «O», to switch the machine off. 16 Select the delayed start by pressing the button 6 Press this button to select the required delay. The selected delay time value will appear on the display for few seconds, then the duration of the programme will appear again. You must select this option after you have set the programme and before you press the button 8. You can cancel the delay time at any moment, before you press button 8. If you have already pressed it, and you wish to cancel the delay time, proceed as follows: · set the washing machine to PAUSE by pressing button 8; · press the button 6 once. On the display will appear the symbol «0'». After closing the door, it is necessary to set the programme and the options again and then to press button 8. At the end of the programme The machine stops automatically. Some acustic signals sound and on the display will appear «0. 00 ». The pilot light of the button 8 and the pilot light 9 go off. If at the end of a programme there is water in the tub (pilot light 9 on and door locked), to empty out the water follow the following instructions: To empty out the water: 1. turn the programme selector dial to «O» 2. select the draining or spinning programme 3. reduce the spin speed, if needed, by means of the button 3 4. at the end of programme, the display shows «0. 00», the pilot light 9 goes off and it will be possible to open the door. At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. [. . . ] For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance. The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door and in the chapter «Technical Data». [. . . ]