User manual ZANUSSI ZFC140T

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. [. . . ] If the appliance is positioned below an overhanging kitchen unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm (Fig. The ideal solution, however, is the one shown in Fig. The appliance can be installed with its sides touching adjacent kitchen units provided that air can circulate freely around the back and top. Accurate levelling is ensured by one or more adjustable feet at the base of the refrigerator. Fig. 1 100 mm A 10 mm B 10 mm NP008 37 Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 38 Door reversibility The appliance must be unplugged before starting work. To reverse the opening direction of the door, proceed as follows: Remove the bottom hinge (5). Unscrew pin (2) from hinge (1) and replace it on the opposite side. Unscrew foot (6) and replace it on the opposite side. Refit the door and bottom hinge (using the holes provided). [. . . ] Do not use metal implements to detach the trays. Defrosting During normal operation, the evaporator in the refrigerator compartment will gradually become covered with frost. This frost is a thermal insulator which inhibits cooling and must therefore be removed, otherwise there will be a significant reduction in cooling efficiency and an increase in electricity consumption. To defrost, proceed as follows: press the button in the centre of the thermostat knob; once defrosted, the refrigerator will start up again automatically but the water which has collected in the special tray located under the evaporator must be removed. 42 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Periods of non-use If you are not using the appliance for any length of time, the following precautions should be taken: unplug the appliance; take all food out; defrost and clean the inside and all the accessories; leave the door ajar so that air can circulate inside in order to prevent unpleasant smells forming. Periodic cleaning Clean the inside with warm water and bicarbonate of soda. [. . . ]