User manual ZANUSSI ZFC18/9SRD

[. . . ] KÜHL-GEFRIERSCHRANK REFRIGERATEURCONGELATEUR KOELDIEPVRIESKAST FRIDGE-FREEZER ZFC 18/9 SRD BEDIENUNGSANLEITUNG 2222133-25 MODE D'EMPLOI GEBRUIKSAANWIJZING INSTRUCTION BOOKLET CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 35 36 36 36 36 36 36 37 38 38 38 38 38 39 39 39 39 40 40 40 40 41 41 41 41 41 41 Installation . Caution . Location . Rear spacers . Electrical connection . . Control panel Operation - Temperature adjustment . [. . . ] If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire by a qualified electrician in accordance with the existing safety regulations. The manufacturer declines to accept any liability should this safety rule not be observed. 87/308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A 10 mm B 10 mm NP002 Rear spacers In the bag with the documentation, there are two spacers which must be fitted as shown in the figure 2. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents which will leave an odour or abrasive powders on the interior, as these will damage the finish. 36 Door reversibility Unplug the appliance from the power supply before carrying out the below-mentioned operations. Remove the freezer door by releasing it from the middle hinge (H). Remove the fridge door by releasing it from the top hinge pin (A). Remove the pin and the washer (A+B) from the top hinge (C), then mount these on the opposite side, after having removed the plugs which must be refitted on the other side. Replace the middle hinge to the left hand side. Screw down the bottom hinge (E) on the opposite side by using the screws previously removed. Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side. The doors can be aligned by adjusting both the middle and top hinges. The middle hinge can be adjusted horizontally, with the help of a tool, after having slackened the two screws. The top hinge is adjusted by slackening the nut with a 10 mm spanner and then proceeding as shown in the Figure. Warning: After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D405 E F F D F D640 F C B A D427 D419 H 37 OPERATION Control panel 3 4 A A. Operating pilot light C D Operation - Temperature adjustment After cleaning the appliance's interior, connect the plug to the wall socket. The temperature inside both the refrigerating and freezing compartments is regulated with the thermostat knob (C). [. . . ] However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. To carry out complete defrosting of the freezer compartment ( ) proceed as follows: Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. Pull out the plug from the wall socket or turn the thermostat knob to the «O» setting. Introduce the plastic scraper in the appropriate seating at the bottom centre, as shown in Figure, place underneath a basin to collect the defrost water. Ice-cube production This appliance is equipped with trays for the production of ice-cubes. [. . . ]