User manual ZANUSSI ZFC19/4D

[. . . ] FRIDGE-FREEZER CHLADNICKA-MRAZÁK CHLODZIARKOZAMRAQARKA ZFC 19/4 D INSTRUCTION BOOKLET NÁVOD NA INSTALACI A POU ËITI INSTRUKCJA OBSLUGI Å È 2222 162-54/1 This document was created with FrameMaker 4. 0. 4 CONTENTS Warnings . . page 3 4 4 4 4 4 5 6 6 6 6 6 7 7 7 7 8 9 9 9 Installation . . page Cleaning the appliance's interior . . page Starting-up and Temperature Regulation . [. . . ] Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For a more efficient operation of the appliance, the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm (see Fig. However, the best solution would be that shown in Fig. Two adjustable feet make it possible to accurately level the appliance. 1 100 mm min. A B Cleaning the appliance's interior D042 Rear spacers Fig. 2 In the plastic envelope containing the Operating Instructions are also included two wall spacers A to be fitted into the special 45° D039 openings provided on the back of the appliance. 4 Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents which will leave an odour or abrasive powders on the interior, as these will damage the finish. Door reversibility Before carrying out any work on the appliance, unplug it from the power socket. 3) and slide the top door off the middle hinge. Remove the middle hinge, turn it through 180° and refit it on the opposite side (Fig. 3a) after having removed the plugs (F-Fig. The plugs must be refitted in the holes left open on the opposite side. Unscrew the left-hand levelling foot, which will be refitted on the opposite side. Unscrew the right-hand levelling foot (H), the corresponding hinge (I) and the stop (L) and refit all these on the left-hand side (Fig. Reverse the handles after having removed the clipin screw covers (Fig. The unused holes are masked with plastic plugs which should be removed and refitted in the holes left open. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. 3d D185 D336 5 OPERATION Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner, clockwise, beyond the «O» position, to start the appliance. [. . . ] Use the special cleaner provided, which you will find already inserted into the discharge hole. 6 The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]