User manual ZANUSSI ZFC19/5D

[. . . ] HUTO-FAGYASZTÓ SZEKRÉNY CHLODZIARKOZAMRAQARKA CHLADNICKA-MRAZÁK FRIDGE-FREEZER ZD 19/5 R MUKÖDÉSI ÉS HASZNÁLATI UTASÍTÁS INSTRUKCJA OBSLUGI NÁVOD NA INSTALACI A POUËITI Å È INSTRUCTION BOOKLET 2222 300-63 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 35 36 36 36 36 36 37 38 38 38 38 39 39 39 40 40 41 41 41 41 41 41 Installation . Positioning . Rear spacers . Electrical connection . . Starting-up and Temperature Regulation . Storage of foods in refrigerator compartment . [. . . ] If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. min. 2 50 cm The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/ 308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 36 Door reversibility Unplug the refrigerator from the wall socket before performing the following operations: Remove the lower hinge (1) and the support foot (2). Unscrew the front left support foot (3) and screw it into the corresponding position on the opposite side. Unscrew the two screws which hide the fixing holes of the hinge on the left-hand side. Detach the lower door from the central hinge (H). D548 Fig. 3 5 Remove the central hinge and detach the upper door from the pin (5). Unscrew the pin (5) and screw it into the corresponding position on the opposite side. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. Re-assemble the lower hinge (1) and the support foot (2) on the opposite side. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D405 Fig. 6 3 1 2 D715 37 OPERATION Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner, clockwise, beyond the «O» position, to start the appliance. [. . . ] Reconnect the appliance to the power supply and then set the thermostat to the coldest position for approximately 2 hours and then shift it into the normal functioning status. Replace the foods previously removed from the freezer and the ice cubes trays. D037 The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]