User manual ZANUSSI ZFC202-1

[. . . ] Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. [. . . ] 2 45° D039 4 Power connection Before plugging in the appliance to the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable. For operation at different voltages, a suitable transformer should be used. The appliance MUST be connected to an efficient earth or ground tap. The supply-lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the finish. 5 Door reversibility Unplug the appliance before performing the following operations: Carefully lay the appliance on its back. Remove the hinge (C) by unscrewing the screws (B). Remove the stop catch (E) by unscrewing the screws (D). Remove the upper hinge and fit on the opposite side (Fig. Reassemble the door, inserting the upper hinge pin into the bushing on the door. Unscrew the left foor and refit on the opposite side. Fit the stop catch (E) on the opposite side. Fit the hinge (C) and foot (A) on the opposite side. The holes that are not used are to be masked with the plastic plugs removed. D473 E C D A Fig. 4 Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. [. . . ] Make sure that the frozen foods have been correctly stored by the retailer. Make sure that the interval between the time when you buy the frozen foods and when you put them in the freezer is short. Do not exceed the dates of expiry marked on the packages by the manufacturer. After a period when the appliance is not used, make it run for at least two hours with the thermostat knob turned to the coldest setting before placing the frozen foods in it. [. . . ]