User manual ZANUSSI ZFC202C

[. . . ] Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] 1-B (without overhanging kitchen furniture). The appliance sides may also be in contact with the kitchen furniture, provided that air can circulate free in the rear and top part. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. For the models designed to be built in the furniture it is necessary to follow the specific instructions regarding building in. 1 100 mm min. A 45° D039 Power connection Before plugging in the appliance to the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable. For operation at different voltages, a suitable transformer should be used. The appliance MUST be connected to an efficient earth or ground tap. The supply-lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. A B D194 Rear spacers In the plastic envelope containing the Operating Instructions are also included two wall spacers to be fitted into the special openings provided on the back of the appliance. Push-fit the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in (arrow in vertical position). This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the finish. 4 Door reversibility Unplug the appliance before performing the following operations: Carefully lay the appliance on its back. Remove the hinge (C) by unscrewing the screws (B). Remove the stop catch (E) by unscrewing the screws (D). Remove the upper hinge and fit on the opposite side (Fig. Reassemble the door, inserting the upper hinge pin into the bushing on the door. Unscrew the left foor and refit on the opposite side. Fit the stop catch (E) on the opposite side. [. . . ] If it is not removed, the temperature inside the fridge increases with a higher power consumption. To carry out defrosting proceed as follows: Press the button in the middle of the thermostat knob (Fig. 10 D113 Storage of frozen food (Mod. ZFC 202 C) The compartment is also suitable for the storage of frozen foods; in this case follow these simple rules: Turn the thermostat knob to the coldest setting (if the room temperature is lower than 20°C it is necessary to arrange the baffleplate so as to obtain a higher temperature in the refrigerating compartment). [. . . ]