User manual ZANUSSI ZFC235CL

[. . . ] Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. This appliance is designed to be operated by adults. [. . . ] This will prevent it from becoming a death-trap for a child. 2 Location Place the appliance as far away as possible from sources of heat, e. g. radiators, heaters, direct sunlight, etc. . The best results are achieved with a room temperature ranging from +18°C to +38°C (class ST) or from +18°C to +43°C (class T). The class of your appliance is shown on its rating plate. Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For more efficient operation of the appliance the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm (Fig. 1-B (without overhanging kitchen furniture). The appliance sides may also be in contact with the kitchen furniture, provided that air can circulate freely round the back and top. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. 1 100 mm min. A 45° D060 Power connection Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable. Make sure the plug and the socket are compatible so that no adaptors need to be used. If necessary, replace the socket with a suitable one. The appliance MUST be connected to an efficient earth or ground tap. The supply-lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. This appliance complies with the relevant UNI standards and with E. E. C. 87/308 of 02. 06. 87 relative to radio interference suppression. [. . . ] If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb, using a new bulb with the same rating. 8 D025 SERVICING If the appliance is not functioning properly check that: the plug is firmly in the wall socket and the mains power switch is on; there is no power failure; the control knob is in the right position. Furthermore, if the appliance seems too noisy check that the sides are not touching furniture that can transmit or amplify noise or vibration. [. . . ]