User manual ZANUSSI ZFC36/46

[. . . ] Internal cleaning, External cleaning, When the appliance is not in use, replacing the bulbs. . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 3 4 4 5 6 7 8 8 9 10 10 11 12 13 13 13 14 14 15 16 16 17 18 TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED FREEZING CAPACITY AVERAGE DAILY UNITS ELECTRICITY* GROSS CAPACITY Fridge Freezer Superchill comp. NET CAPACITY Fridge Freezer Superchill comp. STAR RATING * This figure is based on standard test results in accordance with European Standard EN153. [. . . ] Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. 13 AMP BROWN 7 USE Control panel °C °C S A A - On-Off Button B C D F - Fast freeze button E F G H E - Freezer temperature selector button G - Alarm reset button H - Warning light B - Refrigerator temperature indicator C - Refrigerator temperature selector button D - Freezer temperature indicator After plugging into the mains supply socket, press the On-Off button (A - first button on the left) to switch on the appliance. At this point, the appliance is preset to run at the following temperatures: +5°C in the refrigerator compartment ­18°C in the freezer compartment TEMPERATURE INDICATION The temperatures inside the refrigerator compartment (symbol ) and the freezer compartment (symbol ) are shown by indicators (B) and (D) respectively, located on the control panel next to the appropriate symbols. The indicators show the temperature inside the compartments: Refrigerator temperature indicator (B) Consists of a single digit indicating temperatures between 0°C and +9°C, with temperatures higher than +9°C indicated by means of a steady illuminated dash sign « », and temperatures lower than 0°C indicated by flashing of the same dash sign. Freezer temperature indicator (D) Consists of two digits indicating the temperature inside the freezer compartment. Warning Frequent or prolonged opening of the refrigerator and freezer doors can cause slight variations in temperature: there can also be considerable variations if large quantities of hot or warm food are placed in the appliance. These are the usual operating conditions. It will take a few hours for these temperatures to be reached (as an indication, within about 4 hours of switching on at ambient temperature of about 20°C). When the appliance is switched on at ambient temperature, the displays are as follows: Red warning light (H) flashes; Freezer temperature indicator (D) shows the current temperature in the freezer compartment; Refrigerator temperature indicator (B) shows a steady illuminated dash sign « », which changes to figures as soon as the temperature inside the refrigerator compartment reaches +9°C. To stop warning light (H) from flashing, press alarm reset button (G) (far right-hand side - see "Overtemperature alarm and memory device"). 8 USING THE APPLIANCE For best results, we recommend that various types of food be loaded as follows: 1. Cooked food, drinks, cold meats, food used everyday. These figures indicate the maximum storage time, from the date on which the food was frozen. Details of food being stored, can also be written in pencil on the lower part of the card. Semi-automatic fast freezing To freeze fresh food when the freezer is already in use with food inside it, proceed as follows: Press button (F) for at least 5 seconds; freezer temperature indicator (D) will show the letters SU to indicate that this function is active. Place the food to be frozen in one of the drawers, preferably an empty drawer to avoid raising the temperature of already frozen food. For items weighing up to 3 kg, press button (F) for at least 5 seconds and at the same time place food in the top drawer. For items weighing between 3 and 9 kg, press button (F) for at least 5 seconds 3 hours before placing food in the bottom drawer. For items weighing between 9 and 11 kg, press button (F) for at least 5 seconds 5 hours before placing food in the top and bottom drawers. The fast freeze function stays active for 27 hours and is then automatically switched off, returning the freezer to its previous setting. Fast freeze can be switched off at any time by pressing button (F) for a further 5 seconds. To freeze fresh food immediately after installing and switching on the appliance, or after having cleaned it, proceed as follows: 1. Press button (F) for at least 5 seconds to activate the fast freeze function. Allow the appliance to run empty for at least 6 hours. [. . . ] " Keep work surfaces clean and avoid cross contamination by not using the same work surface or knife, without washing them thoroughly in between. " Use kitchen roll wherever possible for cleaning up food. If you use a dishcloth, be sure to boil it frequently. 15 MAINTENANCE AND CLEANING Before any maintenance or cleaning can be carried out, DISCONNECT the appliance from the electricity supply. Replacing the bulbs (Refrigerator Compartment) The bulbs are easy to replace after removing the cover fixing screw and the cover. 14 Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). [. . . ]