User manual ZANUSSI ZFC40JE

[. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. [. . . ] Make sure that there is nothing at the back, at the top and at the bottom of the appliance to obstruct air circulation. For more efficient operation of the appliance the minimum distance between the top of the appliance and other overhanging kitchen furniture, if any, should be at least 100 mm (Fig. 1/B (without overhanging kitchen furniture). The appliance sides may also be in contact with the kitchen furniture, provided that air can circulate freely round the back and top. One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. 1 100 mm A 10 mm B 10 mm NP008 Rear spacers In the plastic envelope containing the Operating Instructions are also included two wall spacers to be fitted into the special openings provided on the back of the appliance (Fig. Push-fit the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in place (arrow in vertical position). 45° D060 Fig. 2 A 17 Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. Freezer operation can be stopped by turning the thermostat knob to position «O». Fast freezing For fast freezing, turn the N/S knob (B) (Fig. The fast freeze light (D) will come on. Temperature warning light (E) (Fig. 4) This light warns when the temperature inside the freezer compartment has increased to a point at which safe storage of food can no longer be guaranteed. When the appliance is switched on for the first time or when food is placed in the compartment for freezing, this light remains on until the temperature has reached the level required for correct storage. 21 Freezing fresh foods To fast-freeze foods when the appliance has not been in use, switch on the freezer and let it run on the fastfreeze setting for at least three hours before putting the food to be frozen in the compartment. If however the appliance is already in operation, it should run on the fast-freeze setting for at least 24 hours before the food is put in the freezer. During fast freezing the compressor works continuously, using the maximum cooling power. Keep the knob on the same setting for 24 hours after loading the food to be frozen, and then reset the knob to the position for storage of deep frozen foods. It is necessary to consider the freezing capacity of the appliance, that is the maximum amount of food that can be frozen in 24 hours; this capacity is 20 kg. Place packages of deep frozen foods as shown in Fig. Place the food to be frozen in the upper compartments, so that they do not come in contact with already frozen foods, as their higher temperature might increase the temperature of frozen foods. At the end of the freezing period, place the frozen food in other compartments in order to leave room for freezing more food. [. . . ] Do not open the door too often and leave it open only as long as necessary; the temperature increase in fact reduces the food storage life. Make sure all packages are in good condition, otherwise foods might deteriorate. If the packages show signs of humidity or have swollen, the foods may not have been properly stored, so that the product has lost its original quality. When deep frozen foods are bought, always use a thermal bag; they should always be bought last of all. [. . . ]