User manual ZANUSSI ZFC56/2

[. . . ] Any electrical work required to install the appliance should be carried out by a qualified electrician or competent person. Make sure that the cable is not trapped underneath the appliance, nor touches the motor Repairs carried out by inexperienced persons may cause injuries or serious malfunctioning. Make sure the rear part of the appliance stands against a wall as there are working parts which heat up and should not be of easy access. Make sure that there is a continous and adequate ventilation as a failor to do so will result in component failure and possible food loss. [. . . ] m Warning: When using this product, it is necessary to avoid the contact with plastic material because of degradation. Electrical connection Before plugging the appliance into a socket make sure that the voltage and frequency shown on the rating plate correspond to your home supply. It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED». Starting-Up Plug the appliance into the wall socket. Turn the «temperature knob» A (Fig. 1) to intermediate position. 5 REGULATION AND CONTROL Temperature regulation: A FIG. - 1 Allows temperature regulation according to room temperature and usage. 0 = Disconnection of motor. Interior light: H FIG. - 1 Lightens when opening the door of the refrigerator compartment and shuts off when closing the door. It also shuts off turning the temperature regukator to 0 position. When changing the light bulb (see point A-1 «IF SOMETHING DOES NOT WORK»), release the protection X, by removing the screw Y and pushing it as showns in the figure. 6 HOW TO USE YOUR REFRIGERATOR-FREEZER Freezer Compartment: This freezer, marked , is suitable for freezing food and permits long term storage of frozen food. The appliance must be connected for at least 3 hours before introducing food. Freezing of food: 1) Place food on the upper grill I (figure 1). 2) Maintain food for at least 24 hours in that position. Wrap them up adequately or put them into tight closing bags. Follow the instructions given in the cook books, freezing books and wrapping utensiles for better conservation of food. In some models, on the freezer inner door there is usually an schematic drawing showing the conservation time (in months) for the different types of food. It will also depend on the food quality in the moment of freezing and on the specific instructions on packages. 8 MAINTENANCE OF YOUR REFRIGERATOR-FREEZER Prior to undertaking any maintenance operation, be sure to unplug the aplliance Defrosting of the freezer The inner walls of the freezer become gradually covered with a layer of frost keeping in mind not to open the door frequently and keeping the food wrapped up in closed bags. Whenever the thickness of ice reaches 5 mm. Here to proceed as follows: Remove all food staff and place it in the coolest possible place. Remove de ice from the walls with a plastic scraper. Never use any sharp metal tools, electric ovens or similar as these may cause serious damage to the appliance. Once the ice is eliminated clean and dry the appliance Connect the appliance. 9 MAINTENANCE OF YOUR REFRIGERATOR-FREEZER Defrosting of the refrigerator Cleaning Frost is automatically eliminated in the refrigerator. Clean regularly the water drain opening «G» (figure 1). Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet. Use lukewarm water and neutral soap or bicarbonate of soda for cleaning the interior and the exterior of the appliance. [. . . ] Water in the lower part of the refrigerator. The outside of the cabinet gets humid. Draining tube blocked. Clean tube «G» (fig. 1). Wet vegetables have been introduced. High humidity level in the room. This is normal. This is normal. [. . . ]