User manual ZANUSSI ZFK20/8R

[. . . ] KÜHL-GEFRIERSCHRANK REFRIGERATEURCONGELATEUR KOEL-DIEPVRIESKAST FRIDGE-FREEZER FRIGORIFEROCONGELATORE ZK 20/8 R BEDIENUNGSANLEITUNG MODE D'EMPLOI GEBRUIKSAANWIJZING INSTRUCTION BOOKLET LIBRETTO ISTRUZIONI 2222 299-07 WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. General Safety This appliance is designed to be operated by adults. [. . . ] Two adjustable feet at the cabinet base allow accurate levelling of the appliance. 1 100 mm A 10 mm B 10 mm Rear spacers In the bag with the documentation, there are two spacers which must be fitted in the two top corners. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. NP002 Fig. 2 D594 51 Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 52 Door reversibility Unplug the appliance from the power supply before carrying out the below-mentioned operations. Remove the freezer door by releasing it from the middle hinge (H). 3 E F F D F F Remove the fridge door by releasing it from the top hinge pin (A). Remove the pin (5) and refit it on the other side, after having removed the plugs which must be refitted on the other side. Replace the middle hinge to the left hand side. Screw down the bottom hinge (E) on the opposite side by using the screws previously removed. D548 Fig. 3a 5 Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side. The doors can be aligned by adjusting both the middle and top hinges. The middle hinge can be adjusted horizontally, with the help of a tool, after having slackened the two screws. The top hinge is adjusted by slackening the nut with a 10 mm spanner and then proceeding as shown in the Figure. Fig. 3c Warning: After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. If the ambient temperature is cold (i. e. [. . . ] Periodically clean the defrosting water drainage hole of the refrigerator, using the special cleaner already inserted into the discharge hole. The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]