User manual ZANUSSI ZFK22/10DAC

[. . . ] REFRIGERADOR CONGELADOR FRIDGE-FREEZER FRIGORIFICO E CONGELADOR ZFK 22/10 DAC LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES 2222 235-23/1 Warning! The appliance which you have just bought is supplied not only with the instruction manual, but also with a Warranty Card Certificate, on the back of which are written the relative conditions. Please fill in the necessary details on the Card Certificate and send it to the Zanussi Centre covering the area in which the appliance is to be installed. Read this instruction manual carefully and follow the recommendations it provides to benefit from years of excellent service. The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. [. . . ] If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. E F F D F D640 Fig. 4a H Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. D405 TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. GB 20 USE Control panel (Fig. 5) -13 -15 -18 -21 -24 -26 GB S 3 4 S N 3 4 AB Fig. 5 C DE F G H A - Freezer pilot light B - Temperature warning light C - Thermometer D - SUPER operating control light E - Freezer compartment thermostat knob F - NORMAL/SUPER knob G - Refrigerator compartment thermostat knob H - Refrigerator pilot light USE OF THE FREEZER The freezer is marked with the symbol, which means that the compartment is suitable for freezing fresh food and for long-term storage of frozen food. Fast freezing Turn the knob (F-Fig. 5) to «S» (SUPER) setting (pilot light (D) comes on). Warning light (B-Fig. 5) Storing of frozen foods Insert the plug into the wall socket, pilot light (A) will come on; this indicates that the appliance is switched on. To safely store frozen and deep-frozen foods, the temperature inside the freezer must be at least ­18°C or colder. Therefore, we suggest you turn the knob (E) to a medium setting. The temperature inside the freezer is automatically adjusted to ensure safe storage of the food. However if the appliance works in unfavourable room conditions such as poor ventilation, high or low ambient temperature and frequent door openings, it might be necessary to adjust the setting. Turn knob (E) to the higher numbers to obtain lower temperatures and, conversely, to the lower numbers if a less cold temperature is required. Freezer operation can be halted by turning knob (E) to position «O». This light warns when the temperature inside the freezer compartment has increased to a point at which safe storage of food can no longer be guaranteed. When the appliance is switched on for the first time or when food is placed in the compartment for freezing, this light remains on until the temperature has reached the level required for correct storage. 21 Freezer compartment thermometer The thermometer allows you to check the temperature inside the cabinet without opening the freezer door, so ensuring more economical operation of the appliance. To get the best performance from your freezer, the thermometer should show a temperature of ­18°C. For storage: Food can deteriorate if the temperature inside the freezer is too high. Adjust the thermostat to a higher setting. Only change the thermostat position by one mark at a time and wait for the thermometer reading to stabilise before making any further change. Freezing of fresh foods To fast-freeze foods when the appliance has not been in use, switch on the freezer and let it run on the fastfreeze setting for at least three hours before putting the food to be frozen in the compartment. [. . . ] To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required (Fig. 8 D064 For more thorough cleaning, the top door shelf can be removed by pulling it in the direction of the arrows, then refitting it in position (Fig. 9 D066 25 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough (Fig. [. . . ]