User manual ZANUSSI ZFK22/9

[. . . ] KÜHL-GEFRIERSCHRANK REFRIGERATEURCONGELATEUR TWEEDEURSKOELKAST FRIDGE-FREEZER ZFK 22/9 BEDIENUNGSANLEITUNG 2222 011-33 MODE D'EMPLOI GEBRUIKSAANWIJZING INSTRUCTION BOOKLET CONTENTS Warnings . Location . GB . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 33 34 34 34 34 35 36 36 36 36 37 37 37 38 38 38 38 39 39 39 39 39 39 Electrical connection . Cleaning the appliance's interior . . Control panel Operation-Temperature adjustment. . Positioning the door shelves . Freezing of fresh food and storage of commercially frozen food . [. . . ] Do not use detergents or abrasive powders as these will damage the finish. NP002 34 Door reversibility Unplug the appliance from the power supply before carrying out the below-mentioned operations. Remove the freezer door by releasing it from the middle hinge (H). Remove the fridge door by releasing it from the top hinge pin (A). Remove the pin and the washer (A+B) from the top hinge (C), then mount these on the opposite side. Replace the middle hinge to the left hand side. Screw down the bottom hinge (E) on the opposite side by using the screws previously removed. Detach the plug (F) from the ventilation grill (D). To do this, press it in the direction of the arrow. Introduce the plug (G), which is delivered with the appliance, into the hole left free on the opposite side. The holes which are not used are masked by plastic plugs which should be removed and refitted onto the free holes. The doors can be aligned by adjusting both the middle and top hinges. The middle hinge can be adjusted horizontally, with the help of a tool, after having slackened the two screws. The top hinge is adjusted by slackening the nut with a 10 mm spanner and then proceeding as shown in the Figure. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. E F G D F D071 G C B A D427 D426 H D405 35 USE Control panel 3 4 GB A A. Thermostat knob B Operation-Temperature adjustment Connect the plug to the wall socket. Start by using a medium setting and then, later, select the thermostat position most suitable for your requirements. The temperature is adjusted automatically and may be increased (warmer) by turning the knob towards the lower settings or may be decreased (colder) by turning it towards the higher settings. [. . . ] This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. To carry out complete defrosting of the freezer compartment ( ) proceed as follows: Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. [. . . ]