User manual ZANUSSI ZFK23/10R

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 2 IMPOR TANT S AFET Y INS TR UCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. [. . . ] To remove the cubes twist the tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment by using pointed or sharp edged objects. 8 Hints and ideas In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. How to save energy Avoid putting the appliance in a sunny place and near anything that gives off heat. Be sure that the condenser and the compressor are well ventilated. Do not cover the sections where ventilation is. Wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. Do not leave the door open longer than necessary and avoid unnecessary openings. Put warm foods into the appliance only when they are at room temperature. Keep the condenser clean. The appliance and environment This appliance does not contain gases which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. Wait some hours and then check the temperature again. Try to reduce the temperature in the room where the appliance stands. Connect the mains plug properly. Water flows onto the floor. There are too much frost and ice. The thermostatic control can be set wrongly. The compressor The thermostatic control is set wrongly. Doors are not shut properly or do not close tightly. Products in big quantity to be frozen were put in. Neither cooling, nor lighting works. The appliance is noisy. Plug is not connected to the mains socket properly. Start the appliance according to The thermostatic control is not on. instructions in chapter 'Putting it into There is no voltage in the mains socket. (Try to connect another appliance into it. ) The appliance is not supported properly. [. . . ] Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Do not forget to replace the plastic spacer (b) under the hinge. Be careful that the door edges are parallel with the edge of the top panel. Put over the handles (r) on the other side and put the plastic blanking pins (p) supplied in the plastic bag of this instruction book into the holes set free. [. . . ]