User manual ZANUSSI ZFK56/52RF

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home. Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Blue Brown - Earth - Neutral - Live The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Service Force Centre. 87/308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Freezing fresh food When freezing fresh foods set the slider control to the "min" position and turn the thermostat control to a higher setting. In any 24 hours you can freeze up to 6 kg. colder or warmer, then the appliance may not operate correctly. You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4") distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B). There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. NP00 Defrost water drips into the drain pan during the defrost cycle. Water dropping on the defrost heater causes a hissing or popping sound during the defrost cycle. The automatic defrost timer sounds like an electric clock and clicks in and out of the defrost cycle. The compressor will make a humming or pulsating sound while operating. A 45° PR60 Rear spacers The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance. Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in the diagram. Then turn them through 45° (arrow (A) vertical) until they lock into place. DO NOT install in places with restricted ventilation. [. . . ] For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. You MUST ensure that the appliance is switched OFF. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Service Force Centre). [. . . ]