User manual ZANUSSI ZFT 12 JB

[. . . ] ZANUSSI GEFRIERSCHRANK CONGÉLATEUR CONGELATORE FREEZER ZFT 12 JB GEBRAUCHSANLEITUNG MODE D`EMPLOI LIBRETTO D'ISTRUZIONI INSRUCTION BOOK 200380130 DE FR IT GB SV/Za/11. (05. ) GB Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. The symbols below help you to find things more easily: Safety precautions Warnings and information at this symbol serve safety for you and your appliance. Hints, useful information Environmental information Symbol for ideas At this symbol ideas can be found according to food and its storing. [. . . ] The thermostat can be switched off (, , 0" position), which means breaking the circuit of the compressor i. e. Fruits should be put on the tray in thin layers without packaging. After freezing they can be packed and sorted out then placed into the storing compartments. Put warm foods into the appliance only when they are at room temperature. The condenser must be kept clean. The appliance and environment This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the sympol are recyclable. Storing It is practical to replace frozen products into the storing compartments (cages) after freezing has finished so that to make room in the freezing compartment for another freezing. Intermediate freezing does not deteriorate foods already stored. How to make ice cubes To make ice cubes fill the enclosed ice cube tray with water and put it to the frozen food compartment. Wetting the bottom of the tray and setting thermostatic control knob to maximum stage can shorten preparing time. After finishing do not forget to reset the thermostatic control to the suitable stage. Ready ice cubes can be taken out of the tray under running water then twist or hit it. Maintenance Defrosting Bleeding part of the moisture of cooling chamber in form of frost and ice goes with the operation of the appliance. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases, it needs more energy, at a certain thickness it does not allow the door of the freezing compartment to open, possibly the door can be broken. It is possible to scrape off and remove smaller frost and ice with the enclosed ice scraper. Some useful information and advice After opening and closing the door of freezer vacuum will rise inside the appliance because of the low temperature. So wait 2-3 minutes after closing the door - if you want to open it again while inner pressure equalises. Take care of operating the freezer at a position of thermostatic control so that the inside temperature can never go beyond -18 °C, since temperature higher than this can deteriorate frozen foods. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. Hints and ideas In this chapter practical hints and ideas are given about how to use the appliance to reach maximum energy saving and there is environmental information about the appliance as well. The tray in figure is not a piece of accessories to the appliance!When ice coating is so thick that it can not be removed with the frost scraper defrosting is necessary. How to defrost it: Break the circuit of the appliance. Take the frozen foods out of the appliance and put them into a basket lined with paper or cloth. Store them in a possibly cool place or replace them into a frozen or fresh food compartment of a refrigerator. [. . . ] The data label of the appliance is stuck to the wall of the interior beside the vegetable box in the fresh food compartment in the bottom on the left side. All necessary data are there which are needed to the service announcement (type, model, serial number, etc. ). Note here the data from the data label of your appliance: Model Product No. Date of purchase: The manufacturer reserves the right to make any changes in the products. 37 38 SV/Za/11. [. . . ]