User manual ZANUSSI ZFT 13JC

[. . . ] ZANUSSI GEFRIERSCHRANK CONGÉLATEUR CONGELATORE FREEZER ZFT 13 JC GEBRAUCHSANLEITUNG MODE D`EMPLOI LIBRETTO D'ISTRUZIONI INSRUCTION BOOK 200380297 DE FR IT GB SV/Za/14. (06. ) GB Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. The symbols below help you to find things more easily: Safety precautions Warnings and information at this symbol serve safety for you and your appliance. Hints, useful information Environmental information Symbol for ideas At this symbol ideas can be found according to food and its storing. [. . . ] Place a thin layer of the unpacked fruits in the tray. Once they are frozen, the fruits can be packed, sorted and placed in the storage boxes. Adjusting the temperature The internal temperature of the freezer is regulated electronically through five temperature positions and a switch-off << >> setting. Position << -16°C >> indicates the highest (least cold) temperature, while position << -24°C >> is for the lowest (coldest) temperature. Rotate the thermostat in the desired position. In general, it is best to set the thermostat to << -18°C >> but, for the purpose of temperature setting, you should also consider 36 GB Storing It is practical to replace frozen products into the storing compartments (cages) after freezing has finished so that to make room in the freezing compartment for another freezing. Intermediate freezing does not deteriorate foods already stored. Put warm foods into the appliance only when they are at room temperature. The condenser must be kept clean. The appliance and environment This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. The materials used on this appliance marked with the sympol are recyclable. How to make ice cubes To make ice cubes fill the enclosed ice cube tray with water and put it to the frozen food compartment. Wetting the bottom of the tray and setting thermostatic control knob to maximum stage can shorten preparing time. After finishing do not forget to reset the thermostatic control to the suitable stage. Ready ice cubes can be taken out of the tray under running water then twist or hit it. Maintenance Defrosting It is a normal phenomenon that a part of the internal humidity is turned into frost and ice during operation. However, a thick frost or ice layer has an insulating effect and thus reduces the freezing performance leading to rising internal temperatures and higher energy consumption and, above a certain layer thickness, to difficulties in the opening or sudden break of the freezer door. If the formation of frost and ice is not significant, use the spatula (accessory) to remove or scrape off the frost or ice layer. Please note that the tray shown in the figure is not an accessory. Some useful information and advice After opening and closing the door of freezer vacuum will rise inside the appliance because of the low temperature. So wait 2-3 minutes after closing the door - if you want to open it again while inner pressure equalises. Take care of operating the freezer at a position of thermostatic control so that the inside temperature can never go beyond -18 °C, since temperature higher than this can deteriorate frozen foods. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. After a power failure the product will restart and the quick freeze function will be switched on. If not switched off manually, the quick freeze function will be automatically switched off 5 hours later. [. . . ] The data label of the appliance is stuck to the wall of the interior beside the vegetable box in the fresh food compartment in the bottom on the left side. All necessary data are there which are needed to the service announcement (type, model, serial number, etc. ). Note here the data from the data label of your appliance: Model Product No. Date of purchase: The manufacturer reserves the right to make any changes in the products. 40 41 42 SV/Za/14. [. . . ]