User manual ZANUSSI ZFT45/30

[. . . ] Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings or these warnings contact the Customer Care Department. Prior to installation Check the appliance for transport damage. Under no circumstances should a damaged appliance be installed. [. . . ] Fill the ice cube tray full with cold water, place in the freezing compartment and leave to freeze. To remove the cubes twist the tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment by using pointed or sharp edged objects. FTo Make Ice Cubes 8 Hints & T ips Normal Operating Sounds You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing. When the compressor is on, the refrigerant is being pumped round and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor and you will hear a faint 'click' when the thermostat cuts in and out. Energy Saving Advice Do not install the appliance close to sources of heat, such as a boiler or radiator. Locate the appliance in a cool well ventilated room and make sure that the air openings of the appliance are not obstructed. Avoid unnecessary frosting in the cabinet by packing all foodstuffs into airtight packages before placing them in the freezer. Food which is to be frozen (when cool) should be placed in the fridge before being transferred to the freezer. Try to avoid keeping the door open for long periods or opening the door too frequently as warm air will enter the cabinet and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. Food Storage To obtain the best performance from your freezer: Do not store warm food or evaporating liquid. Avoid buying frozen food if you cannot store it straight away. Disconnect the appliance from the electrical supply. Take the lamp cover off in the direction of the arrow and change the bulb. (Type of bulb: 230 V, 15 W, E 14 thread) 4. Replace the lamp cover and fixing screw. Spare bulbs are available from your local Service Force Centre. F To Change the Light Bulb 11 Some thing N o t Wor king If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Possible Cause Problem No power to the appliance No power at the socket. Thermostat control knob is set at , , 0". The appliance is located in an unsuitable position. The temperature in the fridge or freezer is too high The thermostat control knob is set too low. Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the ambient temperature is within the appliances operating limits of 10 °C to 32 °C. [. . . ] Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packaging. Prise out the two white screw covers from the ventilation grille at the bottom of the appliance. Remove the two securing screws and remove the grille. Remove the door by releasing it from the middle hinge. [. . . ]