User manual ZANUSSI ZFU23SF

[. . . ] Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. [. . . ] . 13 Use - The temperature alarm light - Freezing fresh food - Storage of frozen food - Thawing - Ice-cube . . 14 Hints - Hints for freezing - Hints for storage of frozen food - . . 15 Maintenance - Periods of no operation - Periodic cleaning - Defrosting . . 16 Customer service and spare parts - Technical information . . 17 Installation - Location - Rear spacers - Electrical connection . Thermostat knob Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. This freezer compartment has been marked with the symbol , which means that it is suited to the freezing of fresh foods, the conservation of frozen foods and the production of ice-cubes. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: · · · · room temperature; how often the door is opened; the quantity of food stored; location of appliance. Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Starting Insert the power supply plug into the nearest wall socket (the function indicator light (B) will light up indicating that the freezer is receiving electrical input. ) Turn the thermostat knob (E) to the right to a medium setting (the temperature alarm light (A) will light up). To turn off the freezer, turn the thermostat knob to the «G» position. The pilot light remains lit up. Quick-freezing For quick-freezing, press the Super knob (C). The quick-freezing indicator light (B) will then light up. 13 The temperature alarm light (A) The temperature alarm light turns on automatically whenever the temperature within the freezer rises above a certain value which might endanger satisfactory long-term conservation. It is perfectly normal for the temperature alarm light to remain lit up for a short time after the freezer is initially turned on. It will remain lit up until the optimum temperature for the conservation of frozen food is attained. Freezing fresh food The 4-star compartment is suitable for long term storage of commercially frozen food, and for freezing fresh food. If the freezer has already been working for some time, press the Super knob at least 12 hours before introducing the food into the freezer in order to ensure better freezing results. Place the food to be frozen in the compartment as shown in figure. In order to freeze the quantity indicated on the rating plate, arrange the food directly in contact with the cooling surfaces. If the food is frozen in the baskets, the maximum quantity freezable is slightly less. 10 kg 10 kg Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least two hours on the coldest setting, then turn the thermostat knob to the normal operating position. To obtain the best performance from this appliance, you should: if large quantities of food are to be stored, remove all drawers and baskets from appliance (except for the last one at the bottom) and place food on cooling shelves. Pay careful attention not to exceed load limit stated on the side of the upper section (where applicable). [. . . ] Make sure the edge of the door is parallel with the edge of the top. Position and fix the bottom hinge on the opposite side. Remove the cap (e) and position it on the opposite side. Fit the handle on the opposite side and put the plastic caps (contained in the instructions bag) in the free holes. Put the appliance back in its place, level it and wait at least two hours before connecting it. [. . . ]