User manual ZANUSSI ZGF326ICX

[. . . ] Children should be KEPT AWAY until it has cooled. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Zanussi Service Centre. [. . . ] 1 FO 0204 USING THE HOB CORRECTLY To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (see the table beside). It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering. A - Burner cap B - Burner crown C - Ignition candle D - Thermocouple Table of minimum and maximum diameters of pots which can be placed on the burners Burner Big (rapid) Small (Auxiliary) minimum diameter 180 mm. Cleaning and Maintenance · Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Never use abrasive cleaners Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Carefully wash the stainless steel components with water, then wipe them dry with a soft cloth. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. In models provided with electric ignition, this feature is obtained through a ceramic "candle" and a metal electrode (Fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (Fig. PERIODIC MAINTENANCE Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. FO 2110 Fig. Technical Data Gas Burners Rating Rapid Burner (big) Auxiliary Burner (small) Category Setting Gas connection 3 kW (G20) - 2, 8 kW (G30/31) 1 kW HOB RECESS DIMENSIONS II 2H3+ Natural Gas G 20 - 20 mbar G 1/2" Length Width 270 mm. Instruction for the Installer The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. Avoid installing the appliance in the proximity of inflammable materials (e. g. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. IMPORTANT - To ensure a correct operation, a saving of energy and the long-life of the appliance, the feeding pressure of the appliance must correspond to the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". Interpose the sealing between the components as shown in Fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. The adjustable connection allows the feeding pipe to be situated in the site purposefully allocated on the side of the protection box of the hob itself (Fig. [. . . ] ADJUSTMENT OF MINIMUM LEVEL To adjust the minimum level of the burners, proceed as follows: · Light the burner. · Turn the knob on the minimum position. · With a thin screwdriver, adjust the by-pass screw (see Fig. If changing from natural gas to LPG, completely tighten clockwise the screw, until a small regular flame is obtained. [. . . ]