User manual ZANUSSI ZGF642N

[. . . ] It is meant to cook edible foodstuff only and MUST NOT be used for any other purposes. It is dangerous to alter the specification in any way. For hygiene and safety reasons, this appliance should be kept clean at all times. A build-up of fats or other foodstuff could result in a fire. [. . . ] If you cannot light the flame even after several attempts, check the "cap" (Fig. To put the flame out, turn the knob to the symbol . · Always turn the flame down or put it out before taking the pans off the burner. · Fig. 1 Burner FO 0204 minimum diameter 180 mm. 160 mm. Big (rapid) Medium (semirapid) Small (Auxiliary) 4 The Hob Lid In order to make the appliance match with the kitchen design, a lid (not provided) can be fitted on the hob. · The lid is meant to avoid dust to settle on the hob, when it is closed, and to collect splashes of oil or fat, when it is open. Always wipe off any splash of liquid before opening the lid. · Always clean the lid from cooking residues before opening it or taking it off. The crystal lid can splinter when overheated. Always ensure all the burners are off before closing it. · Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Choose fixed connections or use a flexible pipe in AGB (stainless steel). If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven. This hob can be operated by Slochteren gas (G25) with a nominal pressure of 25 mbar or by natural gas with nominal pressure of 20 mbar. No regulation is required for use by these two types of gas. Before fitting the appliance ensure that the installation has the correct voltage for the appliance. At full capacity, the drop in pressure must not exceed 5%. Such a drop in pressure is caused by the following parameters: maximum capacity of meter; diameter and lenght of the tube in front and behind the meter; section of transit of variuos tubes positioned on the circuit; diameter of eventual connections. · · · A) Ramp with ending nut B) Seal C) Adjustable connection IMPORTANT - To ensure a correct operation, a saving of energy and the long-life of the appliance, the voltage pressure of the appliance must correspond to the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". Interpose the sealing between the components as shown in Fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. [. . . ] The yellow/green earth wire must be approximately 2 cm. To open the terminal block and reach the terminals, proceed as follows: · · insert the point of a screwdriver into the visible protrunding part of the terminal block; exert a light pressure and lift (Fig. 6) FO 0073 Earth (yellow/green) Fig. 6 7 Adaptation to different types of gas Injector replacement · · · Remove the pan supports. [. . . ]