User manual ZANUSSI ZGF646IX

[. . . ] GAS HOB ZGF 646 INSTRUCTION BOOKLET RU ENGLISH Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. During Operation It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings. This appliance has been designed for non professional purpose in private houses only. [. . . ] The crystal lid can splinter when overheated. Always ensure all the burners are off before closing it. Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. Wash the enamelled components with warm soapy water. Frequently wash the "caps" and the "crowns" with hot soapy water, carefully taking away any built-up of food. Carefully wash the stainless steel components with water, then wipe them dry with a soft cloth. If the marks are particularly difficult to remove, use common non-abrasive cleaners or specific products. In models provided with electric ignition, this feature is obtained through a ceramic "candle" and a metal electrode (Fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. B) are not obstructed. FO 2237 Pan supports To keep the pan supports in the right position, they are hooked to a couple of special hinges in the back of the hob. Thanks to these hooks, you can lift the pan supports for easier cleaning, as shown in Fig. To take the pan supports completely off the hob, proceed as shown in Fig. 3. Cast iron pan supports (ZGF 646 ICTX) Caution!When removing the cast iron pan supports, lift them up as shown in Fig. Never turn the pan supports on the hinges as shown in Fig. 2, since this could damage them. FO 2238 Fig. 2 Periodic Maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. Fig. 3 4 Technical data Gas Burners Rating Rapid Burner (big) 3, 0 kW (G20) - 2, 8 kW (G30-G31) Semirapid Burner (medium) 2, 0 kW Auxiliary Burner (small) 1, 0 kW Class 3 Appliance Category II2H3B/P Setting Natural Gas G20 20 mbar Gas connection G 1/2" Electric Supply 230 V ~ 50 Hz Hob recess dimensions Length Width 560 mm. 480 mm. Instruction for the Installer The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. [. . . ] Fit the left hand lid hinge (marked S) into the hinge block (Fig. 11); d. Carry out the same operation with the right hand lid hinge (marked D). FO 2035 Fig. 10 Adjusting the lid balance To adjust the lid balance, turn clockwise or anticlockwise the central screw of the right- and left-hand hinges (Fig. 12 8 Installation and assembly These hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. [. . . ]