User manual ZANUSSI ZGF699ITX

[. . . ] This appliance has been designed for cooking edible foodstuff and to be used for domestic nonprofessional purposes only. It must not be used for any other purpose. It is dangerous to alter the specification in any way. For hygiene and safety reasons, this appliance should be kept clean at all times. [. . . ] If you cannot light the flame even after several attempts, check the "cap" (Fig. To put the flame out, turn the knob to the symbol q. · Always turn the flame down or put it out before taking the pans off the burner. Fig. 1 FO 0204 USING THE HOB CORRECTLY To ensure maximum burner efficiency, it is strongly recommended that you use only pots and pans with a flat bottom fitting the size of the burner used, so that flame will not spread beyond the bottom of the vessel (see the table beside). It is also advisable, as soon as a liquid starts boiling, to turn down the flame so that it will barely keep the liquid simmering. Burner minimum diameter 160 mm. 160 mm. Big (rapid) Medium (semirapid) Small (Auxiliary) 3 THE HOB LID In order to make the appliance match with the kitchen design, a lid (not provided) can be fitted on the hob. q The lid is meant to avoid dust to settle on the hob, when it is closed, and to collect splashes of oil or fat, when it is open. q Always wipe off any splash of liquid before opening the lid. q Always clean the lid from cooking residues before opening it or taking it off. The crystal lid can splinter when overheated. Always ensure all the burners are off before closing it. 2. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. GAS CONNECTION Choose fixed connections or use a flexible pipe in stainless steel. If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven. IMPORTANT - To ensure a correct operation, a saving of energy and the long-life of the appliance, the voltage pressure of the appliance must correspond to the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut GJ 1/2". Interpose the sealing between the components as shown in fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. IMPORTANT - When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Use some soapy water, never a flame. A) Ramp with ending nut B) Seal C) Adjustable connection FO 0264 Fig. Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. [. . . ] After connection try out the heating elements allowing them to function for approximately 3 minutes. To open the terminal block and reach the terminals, proceed as follows: q insert the point of a screwdriver into the visible protrunding part of the terminal block; q exert a light pressure and lift (Fig. 8) FO 0257 FO 0073 Neutral Earth (yellow/green) Fig. Adaptation to different types of gas REPLACEMENT OF INJECTORS · · · Remove the pan supports. [. . . ]