User manual ZANUSSI ZGF759ICW

[. . . ] When disposing of an old appliance, make it unusable, by cutting off the cable. During Use This appliance is intended for domestic cooking only. It is not designed for commercial or industrial purposes. When in use a gas cooking appliance will produce heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose. [. . . ] Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. If the control knobs become difficult to turn, please contact your local Service Centre. WHEN THE INSTALLED HOB IS FIRST Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. This hob is provided with a safety device, which will stop the gas flow if the flame accidentally goes off during cooking. To light a burner: Push in the relevant knob and turn it anticlockwise to "maximum position". At the same time, keep the knob pushed down for about 5 seconds. This will allow the "thermocouple" (Fig. D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. Then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" and "crown" (Fig. To put the flame out, turn the knob to the symbol . When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Gas Connection On the end of the shaft (A) , which includes the GJ 1/2" threaded elbow, an adjustable joint is fixed so that the washer (B) is fitted between the components as shown in figure 4. A drop of paint at both edges of the "L" joint (C) will evidence that the good seal of the connection has been tested in the factory. Before connecting the gas supply pipe to the joint (C), the installer will ensure that the paint drop is unbroken and the "L" connector has not been moved by the vibrations during handling and transportation. When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Ensure that the main connection pipe does not exert any strain on the hob. FO 1010 A) End of shaft with nut B) Washer C) Adjustable joint Fig. 4 Cut Out Size The dimensions of the cut-out are given in figure 5. Rectangular cut-out size for hob Dimensions are given in mm. FO 2038 Fig. 5 7 Building in Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface. Building over a kitchen unit with oven If the hob is built into a kitchen unit with an oven underneath, the recess must have the dimensions shown in diagrams 2 and 3, and should also incorporate suitable oven crosspiece supports to ansure an efficient cooling air circulation. Diagrams 4 and 5 give two building-in examples. The electric connection of the hob and the oven should be carried out separately, for electrical safety reasons to permit easy extraction of the oven from the front part of the kitchen unit. Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 1. The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. [. . . ] The rating plate is located on the bottom of the hob. A copy is attached on the back cover of this book. The appliance is supplied with a 3 core flexible supply cord incorporating a plug. Connect the plug to an adequate socket. Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. [. . . ]