User manual ZANUSSI ZGF96XK

[. . . ] This appliance has been designed for cooking edible foodstuff and to be used for domestic nonprofessional purposes only. It must not be used for any other purpose. It is dangerous to alter the specification in any way. For hygiene and safety reasons, this appliance should be kept clean at all times. [. . . ] When removing the cast iron pan supports, lift them up as shown in Fig. Never turn the pan supports on the hinges as shown in Fig. PERIODIC MAINTENANCE Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. l The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. FO 2032 Fig. Technical Data Gas Burners Rating Triple Crown Burner 4, 0 kW Rapid Burner (big) 3, 0 kW (G20) - 2, 8 kW (G30-31) Auxiliary Burner (small) 1, 0 kW Semirapid Burner (medium) 2, 0 kW Class 3 Appliance Category II 2E+3+ Setting Natural Gas 20 mbar / G25 25 mbar Gas connection Electric Supply HOB RECESS DIMENSIONS Length Width G 1/2" 230 V 50 Hz 830 mm. Instruction for the Installer l The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. l Avoid installing the appliance in the proximity of inflammable materials (e. g. l The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The regulation to be applied for this type of installation is NBN D 5I. 003 : "Installations functioning with combustible gas lighter than air". l The appliance must be electrically disconnected before all interventions. between the switch contacts and of a type suitable for the required load in compliance with the current rules. The connection cable has to be placed in order that, in each part, it cannot reach a temperature 90 °C higher than the room temperature. The brown coloured phase cable (fitted in the terminal block contact marked with "L") must always be connected to the network phase. Neutral Earth (yellow/green) REPLACEMENT OF THE VOLTAGE CABLE The connection of the voltage cable to the appliance's terminal block is of type "Y". This means that its replacement requires the specific equipment of a technician. In this case, only cable type H05V2V2-F T90 must be used. The cable section must be suitable to the voltage and the working temperature. The yellow/green earth wire must be approximately 2 cm. To open the terminal block and reach the terminals, proceed as follows: l insert the point of a screwdriver into the visible protrunding part of the terminal block; l exert a light pressure and lift (Fig. Adaptation to different types of gas INJECTORS REPLACEMENT · · · Remove the pan supports. Remove the burner's caps and crowns. With a socket spanner 7 unscrew and remove the injectors (Fig. [. . . ] So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. [. . . ]