User manual ZANUSSI ZGG647ICA

[. . . ] Children should be KEPT AWAY until it has cooled. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Refer to your local Zanussi Service Centre. [. . . ] Should the hob top become heavily soiled, it is recommended that a proper cleaning product is used. The electric ignition is obtained through a ceramic "candle" and a metal electrode (fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. PERIODIC MAINTENANCE Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. l The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. FO 2110 FO 2111 Fig. Mainteinance - Technical Assistance ORIGINAL SPARE PARTS This appliance, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention. For this reason we reccomend that for any problem you contact the dealer who sold it to you, or our nearest authorized Service Centre, specifying the nature of the problem and the particular model which you own. 5 4. Technical Data Gas Burners Rating Rapid Burner 2, 1 kW (GPL) - 2, 3 kW (GZ 50/GZ 35) Semirapid Burner 1, 5 kW (GPL) - 1, 6 kW (GZ 50/GZ 35) Auxiliary Burner 0, 7 kW Category Setting II /II-35, 50, III-X-I-Zt Natural Gas GZ 50 20 mbar Gas connection Electric Supply HOB RECESS DIMENSIONS Length Width 550 mm. Instruction for the Installer l The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. l Avoid installing the appliance in the proximity of inflammable materials (e. g. l The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The regulations to be applied for this type of installation are: DVGW-TRG '86 "Technical standard for the installation of gas appliances"; TRF 1988 "Technical standard for LPG"; l The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. GAS CONNECTION It is indispensible that the connection to the gas mains are carried out by means of an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel). If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven. This hob can be operated by natural gas with nominal pressure of 20 mbar. No regulation is required for use by these two types of gas. Before fitting the appliance ensure that the installation has the correct voltage for the appliance. At full capacity, the drop in pressure must not exceed 5%. [. . . ] 15. A Fig. 14 FO 2108 Fig. 15 FO 2107 a) Sealing gasket 10 POSSIBILITIES FOR INSERTION Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig. The panel fitted under the hob should be easily removable to allow an easy access if a technical assistance intervention is needed. Kitchen unit with oven The hob recess dimensions must comply the indication given in Figs. [. . . ]