User manual ZANUSSI ZGG758ALU

[. . . ] 2 For your safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Description of the hob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Operating instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Touch controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The residual heat indicators remain on even when the hob is off, until the burner and the pan supports have cooled down. 15 How to set the Minute Minder Function You can use the timer as a simple minute minder when none of the burners are operating. The hob must be activated in order to use the timer as a minute minder. If necessary, activate the hob by touching the main ON/OFF Control for about 3 seconds. Touch the Increasing or Decreasing controls to set the required time (max. The timer begins the countdown a few seconds after the time has been set. During the last ten seconds, the timer starts beeping to advise that the timed period is about to end. An acoustic signal sounds at the end of the timed period. signal, touch the Timer To adjust the time setting: or Decreasing 1. Touch the Increasing Control or at any time to adjust the minute minder setting. Touch the Decreasing Control to set the minute minder to zero. 16 Safety and energy-saving advice For a correct use of the hob To ensure maximum burner efficiency and lower gas consumption, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table). If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. For stubborn stains, use normal nonabrasive cleaners or specific products available on the market. NEVER use scouring pads, steel wool or acids for cleaning. The ignition system The electric ignition is obtained through a spark plugand a metal electrode (letter A). Keep these components clean, to avoid difficult lighting, and check that the burner crown holes are not obstructed. A A - Spark plug B - Thermocouple B 20 Something not working? If the hob is not working correctly, please carry out the following checks before contacting your local Service ForceCentre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. PROBLEM THE HOB DOESN'T WORK CAUSE There are blown fuses in the domestic electrical system. Switches are turned off or there is no power at the power outlet. The hob has overheated and a safety device has been set on the four burners. The Child Safety function has been inadvertently activated. SOLUTION Have the fuses replaced. Reset the switches. Touch the main On/Off . "Protection against overheating"). Deactivate the Child Safety function (see par. [. . . ] 1 0 73 0 The hob is designed to be inserted in modular kitchen units with depth of 550 600 mm and having proper characteristics. The building-in is also possible in modular units with a 600 mm width: in this case, the cut-out in the work top must be carried out as shown in Fig. The worktop must be at least 30 mm thick. If the worktop is thicker than 50 mm, it is possible to install the hob on modular units of any width. [. . . ]