User manual ZANUSSI ZGL63IW

[. . . ] A build-up of fats or other foodstuff could result in a fire. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Ensure that all control knobs are in the OFF position when not in use. [. . . ] 160 mm. Big (rapid) Medium (semirapid) Small (auxiliary) Use of electric plates To switch on the plates, turn the relevant knob to the required position. The plates are regulated by a 7 position switch: Position 0: off Position 1: minimum disbursement of heat Position 6: maximum disbursement of heat The pilot light signals the connection of the electric plate. It is important to note that the plate may smoke a little and produce a slightly unpleasant odour when used for the first time. This is quite normal and will disappear after a few minutes. Using the plates correctly · When cooking by electric, saucepans should have a thick base and be perfectly flat in order to ensure total contact with the plate and, consequently, perfect conduction (Fig. Occasionally, saucepans have a thin bottom and these loose their shape over a period of time. In this manner two of the qualities of the electric plate are lost: the even distribution of heat and the saving of energy. As regards the size of the saucepans: for best results, the plate and the saucepan should have the same diameter. The diameter of the saucepan may be slightly larger; a smaller diameter is not advised. Never leave the plates on without a saucepan!Switch off the plate just before the end of cooking time. The heat accumulated by the plate will finish cooking the food and save energy. THE MANUFACTURER WILL NOT ACCEPT LIABILITY, SHOULD ANY OF THE OTHER SAFETY INSTRUCTIONS INCORPORATED IN THIS BOOK OR THE REGULATION IN FORCE BE IGNORED. Gas connection Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. Use the same attention when the hob is combinated with an oven. IMPORTANT - To ensure a correct operation, a saving of energy and the long-life of the appliance, the voltage pressure of the appliance must correspond to the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". Interpose the sealing between the components as shown in Fig. Screw the parts without forcing, adjust the connection in the required direction and tighten everything. IMPORTANT - When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Use some soapy water, never a flame. · · · A) Ramp with ending nut B) Seal C) Adjustable connection FO 0264 Fig. 4 7 Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. [. . . ] 2) Place the sealing gasket (supplied with the hob) on the edges of the cut out: place it exactly on the front and rear edge, taking care that the sealings meet without overlapping; 3) Fix the hob with the relevant screws (Fig. The traction of the screws is able to trace the sealing, any excess of which can be easily removed. The edge of the hob forms a double labyrinth seal which provides a total guarantee against infiltration of liquids. in. a Fig. 10 FO 0199 a) Sealing gasket 10 Possibilities for insertion Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. [. . . ]