User manual ZANUSSI ZGS688ITW

[. . . ] 7 Using the hob correctly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Cleaning and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guarantee . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 For the Installer Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. Then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check the "cap" and "crown" are in the correct position. In the absence of electricity, ignition can occur without the electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the "maximum" position. put the flame out, turn the knob to the To symbol ( ). Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically. 7 Using the hob correctly Practical hints The burners To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used. Triple Crown Burner diameter 18-26 cm Rapid Burner diameter 18-26 cm Front Semi-rapid Burner diameter 12-18 cm Rear Semi-rapid Burner diameter 12-22 cm Auxiliary Burner diameter 8-16 cm · For easier lighting, proceed before putting a pan on the pan support. · Use only pans or pots with flat bottom. · Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. · If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat. vinegar, salt, lemon juice, etc. ) on the cooktop. A B C D - Burner cap - Burner crown - Ignition candle - Thermocouple The Ignition electrode The electric ignition is obtained through a ceramic electrode with a metal electrode (Fig C). Keep these components very clean, to avoid difficult lighting, and check that the burner crown holes (Fig - B) are not obstructed. Triple Crown Burner (ZGS 685) A B D C 10 Technical data Burner gas power (natural gas 20 mbar) Triple crown burner (ZGS 685) Rapid burner (ZGS 645) Semi-rapid burner Auxiliary burner Category Gas supply Gas connection Electric supply 230 V ~ 50 Hz Appliance class 4, 0kW 3, 0 kW 2, 0 kW 1, 0 kW II2H3B/P natural gas G20 (2H) 20 mbar G 1/2" 3 Hob dimensions Width Depth 594 mm 510 mm Cut out dimensions Width Depth 560 mm 480 mm By-pass diameters Burner Auxiliary Semi-rapid Rapid (ZGS 645) Triple crown (ZGS 685) Ø By-pass in 1/100 mm. 28 32 42 56 11 Gas burners NORMAL POWER BURNER kW kW inj. 100/mm Auxiliary burner Semi-rapid burner Rapid burner (ZGS 645) Triplecrown burner (ZGS 685) m3/h inj. 100/mm REDUCED POWER NATURAL GAS G20 (2H) - 20 mbar NORMAL POWER LPG (Butane/Propane) 30 mbar g/h G30 G31 1, 0 2, 0 3, 0 (natural gas) 2, 8 (LPG) 0, 33 0, 45 0, 75 70 96 119 0, 095 0, 190 0, 285 50 71 86 73 145 204 71 143 200 4, 0 1, 2 146 0, 381 98 291 286 Gas burners G20 13 mbar - only Russia NORMAL POWER BURNER kW Auxiliary burner Semi-rapid burner Rapid burner (ZGS 645) Triple crown burner (ZGS 685) 0, 9 1, 4 1, 9 3, 0 kW 0, 33 0, 45 0, 75 1, 2 REDUCED POWER NORMAL POWER NATURAL GAS G20 - 13 mbar inj. 100/mm 80 105 120 147 m3/h 0, 095 0, 148 0, 20 0, 317 12 Installation " " " " The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The appliance must be electrically disconnected before all interventions. If any electric supply to the appliance is required to carry out the work, ensure all the necessary precautions are followed. The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. Avoid installing the appliance in the proximity of inflammable materials (e. g. Injectors replacement · Remove the pan supports. · · Remove the burner's caps and crowns. With a socket spanner 7 unscrew and remove the injectors (Fig. [. . . ] In this case, only cable type H05V2V2-F T90 must be used. The cable section must be suitable to the voltage and the working temperature. The yellow/ green earth wire must be approximately 2 cm. To open the terminal block and reach the terminals, proceed as follows: " insert the point of a screwdriver into the visible protrunding part of the terminal block; " exert a light pressure and lift (Fig. [. . . ]