User manual ZANUSSI ZH6015X

[. . . ] 1 deflector D (special versions only) 2. 7 - n. 1 additional recirculation spigot P (special versions only, see paragraph 4. 4 2 part 1a) 2. 8 - n. 1 wall brackets 1 to fix the canopy hood n. 2 wall brackets 2 to fix the chimney, rawl plugs, screws, and documentation 2. 9 - n. [. . . ] 2) without splashback d = 920 mm minimum. Note: ensure that the wall bracket (I) is levelled. The hood can be aligned or adjusted in height by rotating the adjustment screws (see below). b) Mark on the wall the centres of the two keyholes of the bracket. 3 - Fixing the wall brackets item 2: a) Place one of the two brackets (item 2 fig. 1) 15 mm from the ceiling or from a horizontal line drawn between the top of the adjoining wall cabinets, ensuring that the bracket is level and mark the centres for the keyhole bracket fixing screws. b) Place the other wall bracket (item 2 fig. 1) on the wall at "X" distance. This measurement should be determined by the height of the upper chimney stack and mark the centres for the keyhole bracket fixing screws. 4 - Pilot drill all the hole positions as marked on the wall using an 8 mm drill and fix the wall brackets 1-2 using the rawl plugs and screws supplied. 5 - Splashback (optional) When a splashback is to be fitted, the distance between the cooker hood and the cooking appliances will be determined by the height of the splashback, item F. Nota: The two venting grilles must not be fitted into the chimney stack until the chimney stack has been installed onto the wall above the canopy. 4. 5 - Fitting the telescopic chimney stack (fig. 8) a) Fit the two plastic supports provided to the top part of the hood. b) To fit the upper section item S first expand the chimney slightly to allow it to fit over the wall brackets (item 2 fig. 1) and then secure the upper section using the 4 screws supplied. c) The lower section item I of the chimney stack should be fitted between the lower bracket 2 and the wall. Fix the U-shaped section to the plastic supports, using two of the screws provided in the bag of accessories. 10 d) Chimney hood with grilles: once the chimney stack has been installed, fit the two venting grilles into the apertures located on either side of the lower chimney section. The grilles are marked with two arrows and should be fitted with one arrow pointing upwards and the other toward the front. When the hood is used in the recirculation mode ensure that the grilles are properly secured to the recirculation spigot item R, as illustrated in fig. 9. Part 2a OPERATION AND MAINTENANCE INSTRUCTIONS 1 - Safety warnings It is most important that all the warnings shown in paragraph 3 of the Installation Instructions are strictly observed. Moreover, pay special attention to the following warnings during the use and maintenance of the cooker hood: 1. 1- The grease filters and the charcoal filter should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently over 4 hours per day. [. . . ] When replacing, ensure that the handle faces outwards. 3. 2 - Thin synthetic filter On certain models the metal grease filters are replaced with a lower grille panel containing a paper grease filter with saturation indicators. 1 - The paper filter visible through the perforated metal grille cannot be washed and should be replaced when the violet colour of the dots has spread over the whole surface and, in any case, not later than every 2 months. The manufacturer declines any liability for any injury or damage caused as a result of not following this instruction. 2 - Replacement - To remove the filter for subsequent replacement first open the metal grille panel (fig. [. . . ]