User manual ZANUSSI ZH9020X

[. . . ] Always insist on genuine spare parts. Once you removed all packaging from the appliance, ensure that it is not damaged and the electric cable is in perfect conditions. Otherwise, contact your dealer before proceeding with the installation. This appliance has been designed to be operated by adults and children under supervision. Young children MUST NOT be allowed to tamper with the controls or play near or with the oven. Environmental Information After installation, please dispose of the packaging with due regard to safety and the environment. [. . . ] If this happens, call your local Service Centre. Under no circumstances should you attempt to repair the appliance yourself. ZHM 726 FO 2480 Cooling fan (only in some models) The purpose of the fan is to cool the control panel, the knobs and the oven door handle. The air stream flows out between the control panel and the oven door handle. To ensure proper cooling, the fan will continue to operate even after the oven is turned off, until normal temperature levels have been reached. Fig. 5 When the oven is first installed F Once the oven has been installed: a) set the thermostat knob to MAX and switch the oven function control knob to conventional cooking ; or b) set the oven control knob to MAX (250); c) allow the oven to run empty for approximately 45 minutes; d) open a window for ventilation. During this time, an unpleasant odour may be emitted. This is absolutely normal, and is caused by residues of manufacturing. Once this operation is carried out, let the oven cool down, then clean the oven cavity with a soft cloth soaked in warm soapy water. Before cooking for the first time, carefully wash the shelf and the dripping pan. To open the oven door, always catch the handle in its central part (Fig. 5). 45 The Safety Thermostat 30 2 This device allows you to make the oven switch off automatically once the preset time is over. Therefore, you need to adjust the cooking level depending on meat or fish's thickness. Always remember to place the dripping pan in the lower position with some water in it. Turn the oven function control knob to the relevant symbol ( ) and set the thermostat knob on the required temperature. All cookings must be carried out with the oven door closed Grilling Cooking with the turnspit (ZBN 722) 4 3 2 1 Fig. 6 FO 0019 Place the spit-support frame into the third grid runner from the bottom of the oven (Fig. 7). Pierce and secure well food on the spit. Fit the spit tip into the spit motor drive in the back of the oven and lay its front part on the frame groove. Tutn the oven function control knob on . Set the thermostat function knob on 200°C maximum. Grease Filter (only in some models) When cooking meat, the grease filter must be fitted over the oven fan by clipping it over the vents in the back panel. This will prevent a built-up of fat on the fan impellor. Do not use abrasive materials to clean the seal. When cooking is completed and the oven has cooled down, remove the filter by pushing the protruding tongue on the filter upward. [. . . ] 12 FO 0290 Undertop Recess Dimensions Securing the Oven to the Cabinet The recess must have the dimensions shown in Fig. 13. Fit the appliance into the cabinet recess. Open teh oven door and secure the oven to the kitchen cabinet with four wood screws, which fit the holes provided in the oven frame (Fig. 14). When installing an electric plate hob over the oven, the hob's electrical connection and the oven's one have to be carried out separately, for security reasons and to let the oven be taken off the unit easier, if necessary. Fig. [. . . ]