User manual ZANUSSI ZHC917X2

[. . . ] · The hood should not be used by children or persons not instructed in its correct use. MAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. · Clean and/or replace the Filters after the specified time period. · Clean the hood using a damp cloth and a neutral liquid detergent. GB 14 CHARACTERISTICS Dimensions ø 280 732 898 72 55 500 890 890 min 1170 max 15 GB Components Ref. [. . . ] · For wooden beam ceilings, drill according to the wood screws used. · For wooden shelf, drill ø 7 mm. · For the power supply cable feed, drill ø 10 mm. · For the air outlet (Ducted Version), drill according to the diameter of the external air exhaust duct connection. FIXING THE FRAME Before fixing, separate the two sections of the frame by unscrewing the 6 side screws to obtain the Upper frame and Lower frame. 17 GB Upper frame · Align the power supply cable feed hole · Fix the upper frame to the ceiling or shelf using: · For concrete ceilings, use the appropriate plugs for the screw size (not provided). · For hollow brick ceilings of wall thickness of approximately 20 mm: use 4 plugs 11 and 4 screws 12h, provided. · For wooden beam ceilings, use 4 wood screws (not provided). · For wooden shelf, use 4 screws 12g with washers 22 and nuts 23, provided. Lower frame · Fix the lower frame using the 8 previously removed screws, adjusting the length according to the installation height (hood body lower fixing surface must be at least 720 mm from the hob). · For the recirculation version, turn the frame in the direction chosen for the recirculated air outlet. · The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. Switches the extractor motor on and off at low speed. Used to provide a continuos and silent air change in the presence of light cooking vapours. Reduces the operating speed Increases the operating speed Maximum speed, used for eliminating the highest cooking vapour emission. Switches off automatically after 10 minutes operation. Can also be switched off manually by pressing the button S1 Led S2 Led M Motor V1 Speed V2 Speed V3 Intensive speed GB 20 MAINTENANCE Grease filters CLEANING METAL SELF-SUPPORTING GREASE FILTERS Alarm signal reset · Switch of the lights and extractor motor. · Press button V3 for at least 3 seconds, until the leds start to flash. Cleaning the filters · The filters are washable and must be cleaned when led S1 flashes or at least every 2 months of operation, or more frequently for particularly heavy usage. · Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. · Wash the filters, taking care not to bend them. · When refitting the filters, make sure that the handle is visible on the outside. 21 GB Activated charcoal filter (Recirculation version) REPLACING THE ACTIVATED CHARCOAL FILTER · The filter is not washable and cannot be regenerated. It must be replaced when led S2 flashes or at least every 4 months. [. . . ] · Switch off the lights and extractor motor. · Press button V3 for at least 10 seconds, until the leds start to flash: · 2 flashes of the activated carbon odour filter saturation alarm led = filter ACTIVATED · 1 flash of the activated carbon odour filter saturation alarm led = filter DEACTIVATED Lighting LIGHT REPLACEMENT · 20 W halogen light. · Remove the 2 screws fixing the ring nut. · Extract the lamp from the lamp holder by pulling gently. [. . . ]