User manual ZANUSSI ZI1451

[. . . ] In the event of damage please contact your retailer. The edges and projecting parts of the cabinet may be sharp. Be careful when moving the cabinet and always use gloves. ¥ Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] ¥ Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to keep out as much air as possible. ¥ Milk bottles: these should have a top and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. D040 ¥ Please do the same in reverse to insert the shelf at a different height. The glass shelf above the vegetable drawers and the bottle shelf should always remain in position, to ensure correct air circulation. Door shelves ¥ To permit storage of food packages of various sizes, the door shelves can be adjusted in height. D006 ¥ Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. ¥ For more thorough cleaning, the top door shelves can be removed by pulling them in the direction of the arrows, then refitting them in position. Ice cube production The refrigerator is equipped with one or more ice cube trays, which should be filled with drinking water and placed in the special compartment. Do not use metal implements to detach the trays. 4 Maintenance Unplug the appliance before carrying out any maintenance operation. Changing the light bulb ¥ Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1. unscrew the light cover securing screws. unhook the moving part as shown in the figure. Replace the bulb by other with another with the same charcteristics. Defrosting During normal operation, the evaporator in the refrigerator compartment will gradually become covered with frost. This frost is a thermal insulator which inhibits cooling and must therefore be removed, otherwise there will be a significant reduction in cooling efficiency and an increase in electricity consumption. Press the button in the middle of the thermostat knob; 2. Once defrosted the refrigerator will start up agai automatically. The water which has collected in the tray placed under the evaporator must be removed. Never use metal objects for defrosting your appliance as it may get damaged. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. D731 Cleaning Never use metal objects for cleaning your appliance as it may get damaged. NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour. Clean the inside with warm water and bicarbonate of soda. To guarantee a safe operation of the fridge, once a year remove the ventilation grille at the base and clean the air channels with a vacuum cleaner. When the appliance is not in use Disconnect the appliance from the electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. 5 Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. [. . . ] Apply joint the sealing strip as shown in figure. Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. [. . . ]