User manual ZANUSSI ZI2240

[. . . ] Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. This appliance is designed to be operated by adults. [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. . This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 42 Building-in i nstructions Door reversibility (Fig 1 ) P P 1 P1 D544 P1 Right opening Remove the pins (P) and (P1) fromthe left side. Left opening Remove (P) from both sides and the door. Remove the middle hinge (A) and refit it on the opposite side. Refit the door and (P) on the left side. Remove (P1) from the left side. 50 mm Dimensions of the recess Height Depth Width 1446 mm 550 mm 560 mm D567 min. 200 cm I nstructions for totally built-in appliances 2 Fig. cm 200 2 The applianceÕs door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. GB 45 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the ÇOÈ (STOP) position. The appliance will start to operate. GB Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position ÇOÈ. Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Attention With room temperature lower than +14¡C switch (A) (see Fig. 10) should be depressed (the built-in light will come on). the thermostat knob with respect to the normal running position. Depress the ambient switch at least 3 hours before loading food to be frozen. [. . . ] 13 MEAT FISH SHELLFISH high humidity: MILK BUTTER SOFT CHEESES D730 MUSHROOMS ARTICHOKES ASPARAGUS CAULIFLOWER CARROTS PEARS CHERRIES Defrosting STRAWBERRIES RASPBERRIES PEACHES APRICOTS APPLES RADISHES GRAPES Fig. 14 The ZERO DEGREE compartment defrosts automatically. The defrost water is collected in a small bowl located at the back of the appliance, just above the compressor, from which it evaporates. Fig. 15 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. [. . . ]