User manual ZANUSSI ZI2403

[. . . ] KHLSCHRANK REFRIGERATEUR KOELKAST REFRIGERATOR ZI 1603 ZI 2403 D F BEDIENUNGSANLEITUNG GEBRUIKSAANWIJZING 2222759-20 MODE D'EMPLOI INSTRUCTION BOOKLET Instructions for the use of the instructions booklet Notes which are important for your safety or for the proper functioning of the appliance Supplementary information regarding operation and practical applications of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance Safety Instructions This information has been provided in the interests of your safety. Please read it before installing or using the appliance. Please retain the instruction book for future reference. [. . . ] unscrew the light cover securing screws. unhook the moving part by pressing it as shown in the figure. Replace the bulb by other with another with the same charcteristics. D037 It is important to periodically clean the defrost water drain hole. D411 37 Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions: SYMPTOM Door does not close SOLUTION Level properly the appliances if it is not well levelled. Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. The appliance is not properly installed. Distribute the food products to allow cold air to circulate around them. Make sure that the door is completely closed and that the insulating strip is complete and clean. The temperature where the cabinet is placed is above normal room temperature. Turn the temperature regulator to a warmer setting temporarily. Turn the thermostat knob to a lower number. The temperature where the cabinet is placed is above normal room temperature. Check that the ventilation is sufficient and that the ventilation openings are unobstructed. The cause could be the introduction of large quantities of food and/or frequent opening/closing of the door. During automatic defrosting frost thaws on the cooling plate. Place the drain hose at the back of the cabinet above the drain bowl. Temperature control may cause clicking sounds when the system is connected or disconnected. The injected cooling gas may produce a gurgling sound while passing through the tubes. The motor may cause a humming noise and/or slight bumping. The following table shows which ambient temperature is correct for each climate classification: Climate classification SN N ST T for an ambient temperature of +10 to +32C +16 to +32C +18 to +38C +18 to +43C Positioning Unpack the cabinet and check that it is in good condition and free of any transport damage. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. [. . . ] So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. [. . . ]