User manual ZANUSSI ZI4160

[. . . ] illustration pages on the cover to enable you to compare the text and pictures alongside. Removing the adhesive tapes The doors are secured to the housing with adhesive tapes. Remove any adhesive tape residues with a suitable petroleum-based cleansing agent. Commercial use Should you use your home fridge-freezer commercially or for purposes other than refrigeration, freezing, and deep frozen storage of food and drinks, you must observe the legal requirements applicable to your area. Appliance packaging information All used materials are environmentally compatible!They can be safely disposed of or burnt in a refuse incinerator!Regarding the materials: the plastics can also be recycled and are marked as follows: >PE< for polyethylene e. g. [. . . ] Screw in mounting screws (D) above and below. Cut supplied the sealing strip (F) (Fig. 9) to length and press in between the appliance and kitchen unit side wall. Seal mounting and hinge holes with supplied plugs (G) (Fig. 10). Starting up and temperature regulation Fig. 15 Insert the plug of your fridge-freezer in a plug socket with protective earth contact wired as prescribed. The knob for temperature selection is located in the upper RH part of the refrigerator compartment (A) (Fig. The mark to which the knob must be set is located on top of the thermostat housing (Fig. Rotation in direction "1": Lighting on, refrigerating unit on, the latter then operating automatically. Setting "1" means: Highest temperature, warmest setting. Setting "6" means: Lowest temperature, coldest setting. Place the packaged food to be frozen in the upper storage compartment (9) (Fig. Take special care not to mix already frozen foods with those not yet frozen. After around 24 hours (earlier for smaller quantities), set back the knob of the temperature selector to the normal setting (between 2 and 4). After freezing, you can place the frozen food at the appropriate freezing level. If further food is to be frozen, you must restack the frozen food in the storage compartments (8) (Fig. Note for test centres: Stacking diagrams for determination of freezing capacity and warm-up time can be requested direct from the manufacturer. Adjusting the storage racks Fig. 17a Storage shelves made either of glass or of plastic, are included, depending on which version of which model you have bought. You must push one of these shelves into the lowest set of guides, just above the containers for fruit and vegetables, and it must stay in this position. Never use the freezer as a means of cooling hot meals, since this causes heavy frost formation inside and an increase in electricity consumption. After opening and closing the door of the freezer compartment whilst the latter is in operation, you will not immediately be able to open the door again, since a vacuum will have developed inside, keeping the door closed until the pressures inside and outside the door have equalized. After a few minutes, you can easily re-open the door. Defrosting Figs. 20 and 21 The evaporator on the rear wall of the refrigerator compartment is defrosted fully automatically. [. . . ] After cleaning of the refrigerator compartment, promptly reconnect the appliance to the power supply (see section on Starting up). At least once a year, you should thoroughly clean the heat-emitting condenser (heat exchanger), the metal grille on the rear wall of your appliance. Faults and servicing In order to keep your appliance in perfectly safe condition, you should arrange for repairs, particularly to the "live" parts, to be carried out only by qualified electricians. In the event of a break-down you should therefore contact your electrical dealer or our Customer Service Centre. Before calling the Service Centre, please check whether there is power in the mains socket (e. [. . . ]