User manual ZANUSSI ZI4243

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. 1 Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!, Caution!, Attention!). Please observe the following carefully. 1. Numbered instructions guide you step by step in the operation of the appliance. [. . . ] 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left. A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). Attention: The mains connection cable may only be replaced by a skilled electrician. The result is the build up of a thick layer of frost on the fridge rear wall. If this happens, turn the temperature regulator back to a warmer setting (position "4" to "5"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. 3 3 Goods to be refrigerated can be loaded immediately after switching on, because the storage temperature in the refrigerator is quickly reached. Note: From a food science point of view, +5 °C for the refrigerator compartment should be considered cold enough as a storage temperature. The following effects are of significance in respect of the interior temperature: ­ Ambient temperature; ­ Quantity and temperature of the food stored; ­ Frequency with which the door is opened and how long it is left open ­ A defect in the appliance. Switching off the appliance 1. To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: 1. The water drainage hole must be cleaned regularly (see the section "Cleaning and Maintenance". 26 Cleaning and Maintenance For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. 1 · · · Warning!The appliance may not be connected to the mains during cleaning. Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, danger of electrical shock!Hot vapours can lead to the damage of plastic parts. The appliance must be dry before it is placed back into service. 1. Wrap food in several layers of newspaper. Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Clean the appliance and the interior accessories with a cloth and lukewarm water. Commercially available dish washing detergents may also be used. [. . . ] ­ 89/336/EWG dated 3 May 1989 (including guideline change notice 92/31/ EWG) - EMV guideline ­ 94/2/EG dated 21. 1994 - Directive on Energy Labelling ­ 96/57 EG dated 3. 1996 - Energy Efficiency Requirements of Household Electric Refrigerators, Freezers and Combinations Thereof. 29 Technical Terminology · Refrigerant Liquids that can be used to a generate a cooling effect are known as refrigerants. They have a relatively low boiling-point, indeed so low, that the warmth from the food stored in the fridge or freezer can cause the refrigerant to boil and vaporise. [. . . ]