User manual ZANUSSI ZI4250D

[. . . ] Storage of frozen food Food refrigeration . Movable shelves Defrosting Maintenance . . Positioning the door shelves . Periodic cleaning . . Periods of non-operation. Warning! The appliance which you have just bought is supplied not only with the instruction manual, but also with a Warranty Card Certificate, on the back of which are written the relative conditions. [. . . ] Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. " This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials; it must nevertheless be disposed of in a proper manner, in accordance with regulations for protection of the environment. 12 INSTALLATION If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. 87/308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly. Do not use detergents or abrasive powders as these will damage the finish. Power connection Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. 8 H Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. 10 20m m D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. 9 8mm PR35 The upper compartment can be opened by means of the sliding system illustrated in the previous point, or else by attaching on the door the handle which is supplied as an accessory (see figure). 10a PR34 D029 15 USE Starting-up and temperature regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the top right hand side of the inner liner, clockwise beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. [. . . ] Freezing capacity is shown on the rating plate. Under normal circumstances, to freeze fresh foods it is not necessary to change the setting of the thermostat knob with respect to the normal running position. However, for a faster freezing operation, turn the thermostat knob to the coldest setting; but remember that, in this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the thermostat knob to a warmer setting. [. . . ]