User manual ZANUSSI ZI4454

[. . . ] Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunctioning. Refer to your local Service Centre, and always insist on genuine spare parts. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. This appliance is designed to be operated by adults. [. . . ] If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. . This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 41 I nstructions for totally built-in appliances Door reversibility (Fig. 1) P P A P1 D114 P1 Right opening Remove the pins (P) and (P1) Left opening Remove (P) from both sides and the door. Remove the middle hinge (A) and refit it on the opposite side. Refit the door and (P) on the left side. Remove (P1) from the right side. I nstructions for totally built-in appliances min. 200 cm 2 Dimensions of the recess Height Depth Width 1780 mm 550 mm 560 mm 50 mm Fig. cm 200 2 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. 44 GB USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position «O». Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. remember that, in this condition, the refrigerating compartment temperature might drop below 0°C. If this occurs reset thermostat knob to a warmer setting. To help you make the most of the freezing process, here are some important hints: Place the food to be frozen in the top basket of the freezing compartment as this is the coldest part. [. . . ] Milk bottles: these should trave a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator 46 Fig. 14 D007 Use and features of the «CRISP'N FRESH»filter The glass shelf on top of the vegetable drawer is fitted with a special filter called «CRISP'N FRESH» which ensures the correct amount of ventilation, and significantly reduces the rate of food dehydration; vegetables therefore store better and keep longer. Fig. 15 Cleaning the filter D587 The filter is held by two small support frames which press into position and are therefore easily removed for clearing. [. . . ]