User manual ZANUSSI ZI5120F

[. . . ] Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] For building into kitchen units follow the special "Building-in" instructions given. The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. 50-min. 1 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. D028 min. 2 Push appliance into the housing until stop strip (A) touches the kitchen unit. D022 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Fig. 3 If after having carried out the previously A described operation there is still some space left between the appliance and the kitchen unit, fit the trimming D265 provided together with the appliance on the stop strip (A). 21 Fig. 4 Open the door and push the appliance against the side of the kitchen unit opposite to that of D appliance hinges. Fasten the appliance with 4 C screws provided D020 in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. 5 Press in the joint covers between the appliance and the kitchen unit. Fig. [. . . ] is shown on the rating plate; the freezing process takes 24 hours. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. D068 when defrosting is completed, dry the interior thoroughly; keep the scraper for future use; turn the thermostat knob back to the required setting or replace the plug in the power socket. After two or three hours, reload the previously removed food into the compartment. [. . . ]