User manual ZANUSSI ZI5250D

[. . . ] REFRIGERADOR CONGELADOR FRIDGE-FREEZER ZI 5250 D LIBRO DE INSTRUCCIONES 2222 121-91 INSTRUCTION BOOKLET CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 12 13 13 13 13 13 13 16 16 16 16 16 17 17 17 17 19 19 19 19 19 Installation . Location . Power connection . Cleaning the appliance's interior . . Starting-up and temperature regulation . [. . . ] Do not use detergents or abrasive powders as these will damage the finish. Power connection Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable. For operation using different voltages you should use an autotransformer of suitable capacity. The appliance's plug and the wall socket are fully compatible, without any need to use adaptors, multiple plugs, etc. If this is not the case, the wall socket should be replaced to make it compatible. The appliance MUST be connected to an efficient earth or ground tap. The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. 1 A Instructions for total built-in Door reversibility Right-hand opening Remove the pins (A) and (B). Left-hand opening Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Housing's dimensions Height 1446 mm Depth 550 mm Width 560 mm 1 C 2 3 B D501 D 13 For appropriate venting, follow indications in Fig. 2 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. cm2 200 D033 D Push appliance into housing until stop strip (A) touches the kitchen unit. 3 A D502 C Press in the joint covers between the appliance and the kitchen furniture. 6 D015 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 4 D503 Apply covers (B) on joint cover lugs and into hinge holes. 7 A B D265 D353 14 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. [. . . ] 13 D009 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. [. . . ]