User manual ZANUSSI ZI6120F

[. . . ] Care should be taken when moving it ce lollies can cause frost burns if consumed straight from the appliance. ¥ ¥ of this appliance, the following instructions must be observed: when the ambient temperature drops below the minimum level, the storage temperature in the freezer compartment cannot be guaranteed; therefore it is advisable to use the food stored as soon as possible. Frozen food must not be re-frozen once it has been thawed out. ManufacturersÕ storage recommendations should be strictly adhered to. [. . . ] Temperature adjustment knob B CD E B. Warning lamp Operation Insert the plug into the wall socket. The pilot light will light up, indicating that the appliance is powered. Turn the thermostat knob, clockwise, beyond the Ç0È (STOP) position. The appliance will start to operate. To stop the appliance, turn the thermostat knob to position Ç0È. A medium setting is generally the most suitable. To stop operation, simply turn the thermostat knob to position Ç0È. Fast freezing To start fast-freezing food, press button (B). Pilot light (C) will come on. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob towards minimum or reduced (colder) by rotating the knob towards maximum. However, the exact setting should be chosen keeping in mina that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. Warning light Warning light (E) lights up when the temperature inside the freezer compartment has increased to a value which jeopardizes the long-term storage of food in the compartment. When the appliance is switched on for the first time or when food is placed in the compartment for freezing, it is normal for this light to remain on until the temperature has reached the level required for correct storage. 39 Internal thermometer This indicates the internal temperature of the freezer. It may indicate a temperature above -18¡C when large quantities of food are placed inside for freezing or when the door is left open for a long time. Blue: normal Red: alarm °C Freezing fresh food The 4-star compartment is suitable for long term storage of commercially frozen food, and for freezing fresh food. To fast freeze food, if the appliance has been out of operation, allow it to run on the fast freeze setting for at least three hours before loading food. If, however, the appliance is already in operation, set it run on the fast freeze setting for at least 24 hours before loading the food. Place the food to be frozen in the compartment(s) as shown in the figure. PR202 9 Kg 7 Kg D670 Storage of frozen food When first starting-up after a period out of use, let the appliance run for at least three hours on the fast freeze setting before putting the products in the compartment. Important If there is a power failure when food is in the freezer, do not open the door of the freezer compartment. The frozen food will not be affected if the power cut is of short duration (up to 6-8 hours) and the freezer compartment is full, otherwise, it is recommended that the food should be used within a short time (a temperature increase of the frozen food shortens its safe storage period). . Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. 40 HINTS Hints for freezing To help you make the most of the freezing process, here are some important hints: ¥ ¥ the maximum quantity of food which can be frozen in 24 hrs. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C 44 D727 Press in the joint covers between the appliance and the kitchen unit. D724 Apply covers (B) on joint cover lugs and into hinge holes. B D726 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. A 20m m PR33 Open both the appliance door and that of the kitchen unit to approx. [. . . ]